Adapt autogen for SFd tests

+ Make the skipping logic in autogen more flexible.
+ Do not emit 4c cases when there is too much VMs/containers.
+ Peter says the second -eth- should be renamed away from suites.
+ Regenerate suites so test case names match (new) suite names.

Change-Id: I95ecc47ca07b8bae6693d5d4330811ff55672fc4
Signed-off-by: Vratko Polak <vrpolak@cisco.com>

1 files changed, 0 insertions, 140 deletions

diff --git a/tests/vpp/perf/container_memif/2n-10ge2p1x710-eth-l2bd-eth-8memif-1chain-4dcr-vppip4-mrr.robot b/tests/vpp/perf/container_memif/2n-10ge2p1x710-eth-l2bd-eth-8memif-1chain-4dcr-vppip4-mrr.robot
deleted file mode 100644
index 7d8837438a..0000000000
--- a/tests/vpp/perf/container_memif/2n-10ge2p1x710-eth-l2bd-eth-8memif-1chain-4dcr-vppip4-mrr.robot
+++ /dev/null
@@ -1,140 +0,0 @@
-# Copyright (c) 2019 Cisco and/or its affiliates.
-# Licensed under the Apache License, Version 2.0 (the "License");
-# you may not use this file except in compliance with the License.
-# You may obtain a copy of the License at:
-#
-#     http://www.apache.org/licenses/LICENSE-2.0
-#
-# Unless required by applicable law or agreed to in writing, software
-# distributed under the License is distributed on an "AS IS" BASIS,
-# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
-# See the License for the specific language governing permissions and
-# limitations under the License.
-
-*** Settings ***
-| Resource | resources/libraries/robot/performance/performance_setup.robot
-| ...
-| Force Tags | 2_NODE_SINGLE_LINK_TOPO | PERFTEST | HW_ENV | MRR
-| ... | NIC_Intel-X710 | ETH | L2BDMACLRN | BASE | MEMIF | DOCKER | 1R4C
-| ... | NF_DENSITY | CHAIN | NF_VPPIP4
-| ...
-| Suite Setup | Run Keywords
-| ... | Set up 2-node performance topology with DUT's NIC model | L3
-| ... | Intel-X710
-| ... | AND | Set up performance test suite with MEMIF
-| ...
-| Suite Teardown | Tear down 2-node performance topology
-| ...
-| Test Setup | Set up performance test
-| ...
-| Test Teardown | Run Keywords
-| ... | Tear down performance mrr test
-| ... | AND | Tear down performance test with container
-| ...
-| Test Template | Local Template
-| ...
-| Documentation | *Raw results L2BD test cases with memif 1 chain 4 docker
-| ... | containers*
-| ...
-| ... | *[Top] Network Topologies:* TG-DUT1-TG 2-node circular topology with
-| ... | single links between nodes.
-| ... | *[Enc] Packet Encapsulations:* Eth-IPv4 for L2 bridge domain.
-| ... | *[Cfg] DUT configuration:* DUT1 is configured with two L2 bridge domains
-| ... | and MAC learning enabled. DUT1 tested with 2p10GE NIC X710 by Intel.
-| ... | Container is connected to VPP via Memif interface. Container is running
-| ... | same VPP version as running on DUT. Container is limited via cgroup to
-| ... | use cores allocated from pool of isolated CPUs. There are no memory
-| ... | contraints.
-| ... | *[Ver] TG verification:* In MaxReceivedRate test TG sends traffic
-| ... | at line rate and reports total received/sent packets over trial period.
-| ... | Test packets are generated by TG on links to DUTs. TG traffic profile
-| ... | contains two L3 flow-groups (flow-group per direction, 254 flows per
-| ... | flow-group) with all packets containing Ethernet header, IPv4 header
-| ... | with IP protocol=61 and static payload. MAC addresses are matching MAC
-| ... | addresses of the TG node interfaces.
-
-*** Variables ***
-# X710-DA2 bandwidth limit
-| ${s_limit}= | ${10000000000}
-# Traffic profile:
-| ${traffic_profile}= | trex-sl-2n3n-ethip4-ip4src254-1c4n
-# Container
-| ${container_engine}= | Docker
-| ${container_chain_topology}= | chain_ip4
-
-*** Keywords ***
-| Local Template
-| | [Documentation]
-| | ... | [Cfg] DUT runs L2BD switching config.
-| | ... | Each DUT uses ${phy_cores} physical core(s) for worker threads.
-| | ... | [Ver] Measure MaxReceivedRate for ${framesize}B frames using single\
-| | ... | trial throughput test.
-| | ...
-| | ... | *Arguments:*
-| | ... | - framesize - Framesize in Bytes in integer or string (IMIX_v4_1).
-| | ... | Type: integer, string
-| | ... | - phy_cores - Number of physical cores. Type: integer
-| | ... | - rxq - Number of RX queues, default value: ${None}. Type: integer
-| | ...
-| | [Arguments] | ${framesize} | ${phy_cores} | ${rxq}=${None}
-| | ...
-| | Given Add worker threads and rxqueues to all DUTs | ${phy_cores} | ${rxq}
-| | And Add PCI devices to all DUTs
-| | ${max_rate} | ${jumbo} = | Get Max Rate And Jumbo And Handle Multi Seg
-| | ... | ${s_limit} | ${framesize}
-| | And Apply startup configuration on all VPP DUTs
-| | And Set up performance test with containers
-| | ... | nf_chains=${1} | nf_nodes=${4} | auto_scale=${False}
-| | And Initialize L2 Bridge Domain for multiple chains with memif pairs
-| | ... | nf_chains=${1} | nf_nodes=${4} | auto_scale=${False}
-| | Then Traffic should pass with maximum rate
-| | ... | ${max_rate}pps | ${framesize} | ${traffic_profile}
-
-*** Test Cases ***
-| tc01-64B-1c-eth-l2bd-8memif-1chain-4dcr-vppip4-mrr
-| | [Tags] | 64B | 1C
-| | framesize=${64} | phy_cores=${1}
-
-| tc02-64B-2c-eth-l2bd-8memif-1chain-4dcr-vppip4-mrr
-| | [Tags] | 64B | 2C
-| | framesize=${64} | phy_cores=${2}
-
-| tc03-64B-4c-eth-l2bd-8memif-1chain-4dcr-vppip4-mrr
-| | [Tags] | 64B | 4C
-| | framesize=${64} | phy_cores=${4}
-
-| tc04-1518B-1c-eth-l2bd-8memif-1chain-4dcr-vppip4-mrr
-| | [Tags] | 1518B | 1C
-| | framesize=${1518} | phy_cores=${1}
-
-| tc05-1518B-2c-eth-l2bd-8memif-1chain-4dcr-vppip4-mrr
-| | [Tags] | 1518B | 2C
-| | framesize=${1518} | phy_cores=${2}
-
-| tc06-1518B-4c-eth-l2bd-8memif-1chain-4dcr-vppip4-mrr
-| | [Tags] | 1518B | 4C
-| | framesize=${1518} | phy_cores=${4}
-
-| tc07-9000B-1c-eth-l2bd-8memif-1chain-4dcr-vppip4-mrr
-| | [Tags] | 9000B | 1C
-| | framesize=${9000} | phy_cores=${1}
-
-| tc08-9000B-2c-eth-l2bd-8memif-1chain-4dcr-vppip4-mrr
-| | [Tags] | 9000B | 2C
-| | framesize=${9000} | phy_cores=${2}
-
-| tc09-9000B-4c-eth-l2bd-8memif-1chain-4dcr-vppip4-mrr
-| | [Tags] | 9000B | 4C
-| | framesize=${9000} | phy_cores=${4}
-
-| tc10-IMIX-1c-eth-l2bd-8memif-1chain-4dcr-vppip4-mrr
-| | [Tags] | IMIX | 1C
-| | framesize=IMIX_v4_1 | phy_cores=${1}
-
-| tc11-IMIX-2c-eth-l2bd-8memif-1chain-4dcr-vppip4-mrr
-| | [Tags] | IMIX | 2C
-| | framesize=IMIX_v4_1 | phy_cores=${2}
-
-| tc12-IMIX-4c-eth-l2bd-8memif-1chain-4dcr-vppip4-mrr
-| | [Tags] | IMIX | 4C
-| | framesize=IMIX_v4_1 | phy_cores=${4}