diff options
Diffstat (limited to 'tests/func/ipv4/eth2p-ethip4-ip4base-ip4proxyarp-func.robot')
| -rw-r--r-- | tests/func/ipv4/eth2p-ethip4-ip4base-ip4proxyarp-func.robot | 156 |
1 files changed, 0 insertions, 156 deletions
diff --git a/tests/func/ipv4/eth2p-ethip4-ip4base-ip4proxyarp-func.robot b/tests/func/ipv4/eth2p-ethip4-ip4base-ip4proxyarp-func.robot deleted file mode 100644 index afe4581b16..0000000000 --- a/tests/func/ipv4/eth2p-ethip4-ip4base-ip4proxyarp-func.robot +++ /dev/null @@ -1,156 +0,0 @@ -# Copyright (c) 2016 Cisco and/or its affiliates. -# Licensed under the Apache License, Version 2.0 (the "License"); -# you may not use this file except in compliance with the License. -# You may obtain a copy of the License at: -# -# http://www.apache.org/licenses/LICENSE-2.0 -# -# Unless required by applicable law or agreed to in writing, software -# distributed under the License is distributed on an "AS IS" BASIS, -# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. -# See the License for the specific language governing permissions and -# limitations under the License. - -*** Settings *** -| Resource | resources/libraries/robot/default.robot -| Resource | resources/libraries/robot/interfaces.robot -| Resource | resources/libraries/robot/testing_path.robot -| Resource | resources/libraries/robot/ipv4.robot -| Resource | resources/libraries/robot/traffic.robot -| Library | resources.libraries.python.Trace -| Library | resources.libraries.python.ProxyArp -| Force Tags | HW_ENV | VM_ENV | 3_NODE_SINGLE_LINK_TOPO -| Test Setup | Set up functional test -| Test Teardown | Tear down functional test -| Documentation | *RFC1027 Proxy ARP test cases* -| ... -| ... | *[Top] Network topologies:* TG-DUT1 2-node topology with -| ... | single link between nodes. -| ... | *[Cfg] DUT configuration:* DUT1 is configured with Proxy ARP -| ... | *[Ver] TG verification:* Test ARP Request packet is sent -| ... | from TG on link to DUT1; on receive TG verifies ARP reply packet -| ... | for correctness and their IPv4 src-addr, dst-addr and MAC addresses. -| ... | *[Ref] Applicable standard specifications:* RFC1027. - -*** Variables *** -| ${tg_to_dut1_ip}= | 10.0.0.100 -| ${dut1_to_tg_ip}= | 10.0.0.1 -| ${prefix_length}= | 24 -| ${lo_ip4_addr}= | 192.168.1.2 -| ${hi_ip4_addr}= | 192.168.1.10 -| ${pass_test_ip}= | 192.168.1.5 -| ${pass_test_lo_ip}= | 192.168.1.2 -| ${pass_test_hi_ip}= | 192.168.1.10 -| ${fail_test_lo_ip}= | 192.168.1.1 -| ${fail_test_hi_ip}= | 192.168.1.11 - -*** Test Cases *** -| TC01: DUT sends ARP reply on behalf of another machine from the IP range -| | [Documentation] -| | ... | [Top] TG-DUT1. -| | ... | [Ref] RFC1027. -| | ... | [Cfg] On DUT1 configure interface IPv4 address and proxy ARP -| | ... | for IP range. -| | ... | [Ver] Make TG send ARP request to DUT1 interface, -| | ... | verify if DUT1 sends correct ARP reply on behalf of machine which -| | ... | IP is in range. -| | Given Configure path in 3-node circular topology -| | ... | ${nodes['TG']} | ${nodes['DUT1']} | ${nodes['DUT2']} | ${nodes['TG']} -| | And Set interfaces in 3-node circular topology up -| | ${dut1_to_tg_name}= | Get interface name | ${dut1_node} | ${dut1_to_tg} -| | ${tg_to_dut1_name}= | Get interface name | ${tg_node} | ${tg_to_dut1} -| | When Set Interface Address | ${dut1_node} -| | ... | ${dut1_to_tg} | ${dut1_to_tg_ip} | ${prefix_length} -| | And Vpp Add Proxy ARP | ${dut1_node} | ${lo_ip4_addr} | ${hi_ip4_addr} -| | And Vpp Proxy ARP Interface Enable | ${dut1_node} | ${dut1_to_tg_name} -| | Then Send ARP Request | ${tg_node} | ${tg_to_dut1_name} -| | ... | ${tg_to_dut1_mac} | ${dut1_to_tg_mac} -| | ... | ${tg_to_dut1_ip} | ${pass_test_ip} - -| TC02: DUT sends ARP reply on behalf of another machine from beginning of the IP range -| | [Documentation] -| | ... | [Top] TG-DUT1. -| | ... | [Ref] RFC1027. -| | ... | [Cfg] On DUT1 configure interface IPv4 address and proxy ARP -| | ... | for IP range. -| | ... | [Ver] Make TG send ARP request to DUT1 interface, -| | ... | verify if DUT1 sends correct ARP reply on behalf of machine which -| | ... | IP is from beginning of the IP range. -| | Given Configure path in 3-node circular topology -| | ... | ${nodes['TG']} | ${nodes['DUT1']} | ${nodes['DUT2']} | ${nodes['TG']} -| | And Set interfaces in 3-node circular topology up -| | ${dut1_to_tg_name}= | Get interface name | ${dut1_node} | ${dut1_to_tg} -| | ${tg_to_dut1_name}= | Get interface name | ${tg_node} | ${tg_to_dut1} -| | When Set Interface Address | ${dut1_node} -| | ... | ${dut1_to_tg} | ${dut1_to_tg_ip} | ${prefix_length} -| | And Vpp Add Proxy ARP | ${dut1_node} | ${lo_ip4_addr} | ${hi_ip4_addr} -| | And Vpp Proxy ARP Interface Enable | ${dut1_node} | ${dut1_to_tg_name} -| | Then Send ARP Request | ${tg_node} | ${tg_to_dut1_name} -| | ... | ${tg_to_dut1_mac} | ${dut1_to_tg_mac} -| | ... | ${tg_to_dut1_ip} | ${pass_test_lo_ip} - -| TC03: DUT sends ARP reply on behalf of another machine from end of the IP range -| | [Documentation] -| | ... | [Top] TG-DUT1. -| | ... | [Ref] RFC1027. -| | ... | [Cfg] On DUT1 configure interface IPv4 address and proxy ARP -| | ... | for IP range. -| | ... | [Ver] Make TG send ARP request to DUT1 interface, -| | ... | verify if DUT1 sends correct ARP reply on behalf of machine which -| | ... | IP is from end of the IP range. -| | Given Configure path in 3-node circular topology -| | ... | ${nodes['TG']} | ${nodes['DUT1']} | ${nodes['DUT2']} | ${nodes['TG']} -| | And Set interfaces in 3-node circular topology up -| | ${dut1_to_tg_name}= | Get interface name | ${dut1_node} | ${dut1_to_tg} -| | ${tg_to_dut1_name}= | Get interface name | ${tg_node} | ${tg_to_dut1} -| | When Set Interface Address | ${dut1_node} -| | ... | ${dut1_to_tg} | ${dut1_to_tg_ip} | ${prefix_length} -| | And Vpp Add Proxy ARP | ${dut1_node} | ${lo_ip4_addr} | ${hi_ip4_addr} -| | And Vpp Proxy ARP Interface Enable | ${dut1_node} | ${dut1_to_tg_name} -| | Then Send ARP Request | ${tg_node} | ${tg_to_dut1_name} -| | ... | ${tg_to_dut1_mac} | ${dut1_to_tg_mac} -| | ... | ${tg_to_dut1_ip} | ${pass_test_hi_ip} - -| TC04: DUT does not send ARP reply on behalf of another machine from below of the IP range -| | [Documentation] -| | ... | [Top] TG-DUT1. -| | ... | [Ref] RFC1027. -| | ... | [Cfg] On DUT1 configure interface IPv4 address and proxy ARP -| | ... | for IP range. -| | ... | [Ver] Make TG send ARP request to DUT1 interface, -| | ... | verify if DUT1 does not send ARP reply on behalf of machine which -| | ... | IP is from below of the IP range. -| | Given Configure path in 3-node circular topology -| | ... | ${nodes['TG']} | ${nodes['DUT1']} | ${nodes['DUT2']} | ${nodes['TG']} -| | And Set interfaces in 3-node circular topology up -| | ${dut1_to_tg_name}= | Get interface name | ${dut1_node} | ${dut1_to_tg} -| | ${tg_to_dut1_name}= | Get interface name | ${tg_node} | ${tg_to_dut1} -| | When Set Interface Address | ${dut1_node} -| | ... | ${dut1_to_tg} | ${dut1_to_tg_ip} | ${prefix_length} -| | And Vpp Add Proxy ARP | ${dut1_node} | ${lo_ip4_addr} | ${hi_ip4_addr} -| | And Vpp Proxy ARP Interface Enable | ${dut1_node} | ${dut1_to_tg_name} -| | Then ARP request should fail | ${tg_node} | ${tg_to_dut1_name} -| | ... | ${tg_to_dut1_mac} | ${dut1_to_tg_mac} -| | ... | ${tg_to_dut1_ip} | ${fail_test_lo_ip} - -| TC05: DUT does not send ARP reply on behalf of another machine from above of the IP range -| | [Documentation] -| | ... | [Top] TG-DUT1. -| | ... | [Ref] RFC1027. -| | ... | [Cfg] On DUT1 configure interface IPv4 address and proxy ARP -| | ... | for IP range. -| | ... | [Ver] Make TG send ARP request to DUT1 interface, -| | ... | verify if DUT1 does not send ARP reply on behalf of machine which -| | ... | IP is from above of the IP range. -| | Given Configure path in 3-node circular topology -| | ... | ${nodes['TG']} | ${nodes['DUT1']} | ${nodes['DUT2']} | ${nodes['TG']} -| | And Set interfaces in 3-node circular topology up -| | ${dut1_to_tg_name}= | Get interface name | ${dut1_node} | ${dut1_to_tg} -| | ${tg_to_dut1_name}= | Get interface name | ${tg_node} | ${tg_to_dut1} -| | When Set Interface Address | ${dut1_node} -| | ... | ${dut1_to_tg} | ${dut1_to_tg_ip} | ${prefix_length} -| | And Vpp Add Proxy ARP | ${dut1_node} | ${lo_ip4_addr} | ${hi_ip4_addr} -| | And Vpp Proxy ARP Interface Enable | ${dut1_node} | ${dut1_to_tg_name} -| | Then ARP request should fail | ${tg_node} | ${tg_to_dut1_name} -| | ... | ${tg_to_dut1_mac} | ${dut1_to_tg_mac} -| | ... | ${tg_to_dut1_ip} | ${fail_test_hi_ip} |