# Copyright (c) 2019 Cisco and/or its affiliates.
# Licensed under the Apache License, Version 2.0 (the "License");
# you may not use this file except in compliance with the License.
# You may obtain a copy of the License at:
#
#     http://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing, software
# distributed under the License is distributed on an "AS IS" BASIS,
# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
# See the License for the specific language governing permissions and
# limitations under the License.

*** Settings ***
| Resource | resources/libraries/robot/shared/default.robot
| Resource | resources/libraries/robot/ip/ip4.robot
| Resource | resources/libraries/robot/shared/interfaces.robot
| Resource | resources/libraries/robot/shared/traffic.robot
| ...
| Force Tags | 2_NODE_SINGLE_LINK_TOPO | DEVICETEST | HW_ENV | DCR_ENV
| ... | FUNCTEST | IP4FWD | BASE | ETH | IP4BASE
| ...
| Suite Setup | Setup suite single link
| Test Setup | Setup test
| Test Teardown | Tear down test | packet_trace
| ...
| Documentation | *IPv4 routing test cases*
| ...
| ... | *[Top] Network Topologies:* TG-DUT1-TG 2-node circular topology \
| ... | with single links between nodes.
| ... | *[Enc] Packet Encapsulations:* Eth-IPv4-ICMPv4 for IPv4 routing on \
| ... | both links.
| ... | *[Cfg] DUT configuration:* DUT1 is configured with IPv4 routing and \
| ... | two static IPv4 /24 route entries.
| ... | *[Ver] TG verification:* Test ICMPv4 Echo Request packets are sent in \
| ... | one direction by TG on links to DUT1; on receive TG verifies packets \
| ... | for correctness and their IPv4 src-addr, dst-addr and MAC addresses.
| ... | *[Ref] Applicable standard specifications:* RFC791, RFC826, RFC792

*** Variables ***
| @{plugins_to_enable}= | dpdk_plugin.so
| ${nic_name}= | virtual
| ${tg_to_dut_if1_ip4}= | 10.10.10.2
| ${tg_to_dut_if2_ip4}= | 20.20.20.2
| ${dut_to_tg_if1_ip4}= | 10.10.10.1
| ${dut_to_tg_if2_ip4}= | 20.20.20.1
| ${remote_host1_ip4}= | 192.168.0.1
| ${remote_host2_ip4}= | 192.168.0.2
| ${remote_host_ip4_prefix}= | 32

*** Test Cases ***
| tc01-eth2p-ethicmpv4-ip4base-device_echo-req-to-dut-ingress-interface
| | [Documentation]
| | ... | Make TG send ICMPv4 Echo Req to DUT1 ingress interface. Make TG \
| | ... | verify ICMP Echo Reply is correct.
| | ...
| | ${hops}= | Set Variable | ${0}
| | ...
| | Given Add PCI devices to all DUTs
| | And Apply startup configuration on all VPP DUTs
| | And VPP Enable Traces On All Duts | ${nodes}
| | When Configure path in 2-node circular topology
| | ... | ${nodes['TG']} | ${nodes['DUT1']} | ${nodes['TG']}
| | And Configure IPv4 forwarding in circular topology | ${tg_to_dut_if1_ip4}
| | ... | ${tg_to_dut_if2_ip4} | ${dut_to_tg_if1_ip4} | ${dut_to_tg_if2_ip4}
| | When All Vpp Interfaces Ready Wait | ${nodes}
| | Then Send IPv4 ping packet and verify headers | ${tg_node}
| | ... | ${tg_to_dut_if1} | ${dut_node} | ${dut_to_tg_if1}
| | ... | ${tg_to_dut_if1_ip4} | ${dut_to_tg_if1_ip4} | ${dut_to_tg_if1_mac}
| | ... | ${hops}
| | Get interface Ipv4 addresses | ${nodes['DUT1']} | ${dut_to_tg_if1}

| tc02-eth2p-ethicmpv4-ip4base-device_echo-req-to-dut-egress-interface
| | [Documentation]
| | ... | Make TG send ICMPv4 Echo Req towards DUT1 egress interface. Make TG \
| | ... | verify ICMP Echo Reply is correct.
| | ...
| | ${hops}= | Set Variable | ${0}
| | ...
| | Given Add PCI devices to all DUTs
| | And Apply startup configuration on all VPP DUTs
| | And VPP Enable Traces On All Duts | ${nodes}
| | When Configure path in 2-node circular topology
| | ... | ${nodes['TG']} | ${nodes['DUT1']} | ${nodes['TG']}
| | And Configure IPv4 forwarding in circular topology | ${tg_to_dut_if1_ip4}
| | ... | ${tg_to_dut_if2_ip4} | ${dut_to_tg_if1_ip4} | ${dut_to_tg_if2_ip4}
| | When All Vpp Interfaces Ready Wait | ${nodes}
| | Then Send IPv4 ping packet and verify headers | ${tg_node}
| | ... | ${tg_to_dut_if1} | ${dut_node} | ${dut_to_tg_if2}
| | ... | ${tg_to_dut_if1_ip4} | ${dut_to_tg_if2_ip4} | ${dut_to_tg_if1_mac}
| | ... | ${hops}

| tc03-eth2p-ethicmpv4-ip4base-device_echo-req-to-tg-interface-for-local-ipv4-address
| | [Documentation]
| | ... | Make TG send ICMPv4 Echo Req between its interfaces across DUT1 for \
| | ... | locally connected IPv4 addresses. Make TG verify ICMPv4 Echo Replies \
| | ... | are correct.
| | ...
| | ${hops}= | Set Variable | ${1}
| | ...
| | Given Add PCI devices to all DUTs
| | And Apply startup configuration on all VPP DUTs
| | And VPP Enable Traces On All Duts | ${nodes}
| | When Configure path in 2-node circular topology
| | ... | ${nodes['TG']} | ${nodes['DUT1']} | ${nodes['TG']}
| | And Configure IPv4 forwarding in circular topology | ${tg_to_dut_if1_ip4}
| | ... | ${tg_to_dut_if2_ip4} | ${dut_to_tg_if1_ip4} | ${dut_to_tg_if2_ip4}
| | When All Vpp Interfaces Ready Wait | ${nodes}
| | Then Send IPv4 ping packet and verify headers | ${tg_node}
| | ... | ${tg_to_dut_if1} | ${tg_node} | ${tg_to_dut_if2}
| | ... | ${tg_to_dut_if1_ip4} | ${tg_to_dut_if2_ip4} | ${dut_to_tg_if1_mac}
| | ... | ${hops}

| tc04-eth2p-ethicmpv4-ip4base-device_echo-req-to-tg-interface-for-remote-host-ipv4-address
| | [Documentation]
| | ... | Make TG send ICMPv4 Echo Req between its interfaces across DUT1 for \
| | ... | remote host IPv4 addresses. Make TG verify ICMPv4 Echo Replies are \
| | ... | correct.
| | ...
| | ${hops}= | Set Variable | ${1}
| | ...
| | Given Add PCI devices to all DUTs
| | And Apply startup configuration on all VPP DUTs
| | And VPP Enable Traces On All Duts | ${nodes}
| | When Configure path in 2-node circular topology
| | ... | ${nodes['TG']} | ${nodes['DUT1']} | ${nodes['TG']}
| | And Configure IPv4 forwarding in circular topology | ${tg_to_dut_if1_ip4}
| | ... | ${tg_to_dut_if2_ip4} | ${dut_to_tg_if1_ip4} | ${dut_to_tg_if2_ip4}
| | ... | remote_host1_ip4=${remote_host1_ip4}
| | ... | remote_host2_ip4=${remote_host2_ip4}
| | ... | remote_host_ip4_prefix=${remote_host_ip4_prefix}
| | And VPP Get IP tables | ${dut_node}
| | When All Vpp Interfaces Ready Wait | ${nodes}
| | Then Send IPv4 ping packet and verify headers | ${tg_node}
| | ... | ${tg_to_dut_if1} | ${tg_node} | ${tg_to_dut_if2}
| | ... | ${remote_host1_ip4} | ${remote_host2_ip4} | ${dut_to_tg_if1_mac}
| | ... | ${hops}