aboutsummaryrefslogtreecommitdiffstats
path: root/tests/vpp/device/container_memif/eth2p-eth-l2bdbasemaclrn-eth-2memif-1dcr-dev.robot
blob: 6d4cffd8344d8ef7f4d590e42a3cf834b7ccf191 (plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
# Copyright (c) 2019 Cisco and/or its affiliates.
# Licensed under the Apache License, Version 2.0 (the "License");
# you may not use this file except in compliance with the License.
# You may obtain a copy of the License at:
#
#     http://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing, software
# distributed under the License is distributed on an "AS IS" BASIS,
# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
# See the License for the specific language governing permissions and
# limitations under the License.

*** Settings ***
| Resource | resources/libraries/robot/shared/default.robot
| Resource | resources/libraries/robot/l2/l2_bridge_domain.robot
| Resource | resources/libraries/robot/l2/l2_traffic.robot
| Resource | resources/libraries/robot/shared/testing_path.robot
| ...
| Force Tags | 2_NODE_SINGLE_LINK_TOPO | DEVICETEST | HW_ENV | DCR_ENV
| ... | FUNCTEST | L2BDMACLRN | BASE | ETH | MEMIF | DOCKER
| ...
| Suite Setup | Setup suite single link
| Test Setup | Setup test
| Test Teardown | Tear down test | packet_trace | container
| ...
| Documentation | *L2 bridge-domain test cases with memif interface*
| ...
| ... | *[Top] Network Topologies:* TG-DUT1-TG 2-node circular topology \
| ... | with single links between nodes.
| ... | *[Enc] Packet Encapsulations:* Eth-IPv4-ICMPv4 for L2 switching of \
| ... | IPv4; Eth-IPv6-ICMPv6 for L2 switching of IPv6 use. Both apply to all \
| ... | links.
| ... | *[Cfg] DUT configuration:* DUT1 is configured with L2 bridge-domain \
| ... | switching. Container is connected to VPP via Memif interface. \
| ... | Container is running same VPP version as running on DUT.
| ... | *[Ver] TG verification:* Test ICMPv4 (or ICMPv6) Echo Request packets \
| ... | are sent in both directions by TG on links to DUT1 and via container; \
| ... | on receive TG verifies packets for correctness and their IPv4 (IPv6) \
| ... | src-addr, dst-addr and MAC addresses.pecifications:* RFC792

*** Variables ***
| @{plugins_to_enable}= | dpdk_plugin.so | memif_plugin.so
| ${nic_name}= | virtual
# L2BD
| ${bd_id1}= | 1
| ${bd_id2}= | 2
# Memif
| ${sock_base}= | memif-DUT1_CNF
# Container
| ${container_engine}= | Docker
| ${container_chain_topology}= | chain_functional

*** Test Cases ***
| tc01-eth2p-ethip4-l2bdbase-eth-2memif-1dcr-device
| | [Documentation]
| | ... | [Top] TG=DUT=DCR. [Enc] Eth-IPv4-ICMPv4. [Cfg] Configure two \
| | ... | L2 bridge-domains (L2BD) with MAC learning enabled on DUT1, each \
| | ... | with one untagged interface to TG and untagged i/f to docker over \
| | ... | memif. [Ver] Make TG send ICMPv4 Echo Req in both directions between \
| | ... | two of its interfaces to be switched by DUT1; verify all packets are \
| | ... | received.
| | ...
| | Given Add PCI devices to all DUTs
| | And Apply startup configuration on all VPP DUTs
| | And VPP Enable Traces On All Duts | ${nodes}
| | When Configure path in 2-node circular topology
| | ... | ${nodes['TG']} | ${nodes['DUT1']} | ${nodes['TG']}
| | And Start containers for device test
| | And Configure interfaces in path up
| | When Set up memif interfaces on DUT node | ${dut_node} | ${sock_base}
| | ... | ${sock_base} | dcr_uuid=${dcr_uuid}
| | ... | memif_if1=memif_if1 | memif_if2=memif_if2 | rxq=${0} | txq=${0}
| | And Create bridge domain | ${dut_node} | ${bd_id1}
| | And Add interface to bridge domain | ${dut_node} | ${dut_to_tg_if1}
| | ... | ${bd_id1}
| | And Add interface to bridge domain | ${dut_node} | ${memif_if1}
| | ... | ${bd_id1}
| | And Create bridge domain | ${dut_node} | ${bd_id2}
| | And Add interface to bridge domain | ${dut_node} | ${dut_to_tg_if2}
| | ... | ${bd_id2}
| | And Add interface to bridge domain | ${dut_node} | ${memif_if2}
| | ... | ${bd_id2}
| | Then Send ICMPv4 bidirectionally and verify received packets | ${tg_node}
| | ... | ${tg_to_dut_if1} | ${tg_to_dut_if2}

| tc02-eth2p-ethip6-l2bdbase-eth-2memif-1dcr-device
| | [Documentation]
| | ... | [Top] TG=DUT=DCR. [Enc] Eth-IPv6-ICMPv6. [Cfg] Configure two \
| | ... | L2 bridge-domains (L2BD) with MAC learning enabled on DUT1, each \
| | ... | with one untagged interface to TG and untagged i/f to docker over \
| | ... | memif. [Ver] Make TG send ICMPv4 Echo Req in both directions between \
| | ... | two of its interfaces to be switched by DUT1; verify all packets are \
| | ... | received.
| | ...
| | Given Add PCI devices to all DUTs
| | And Apply startup configuration on all VPP DUTs
| | And VPP Enable Traces On All Duts | ${nodes}
| | When Configure path in 2-node circular topology
| | ... | ${nodes['TG']} | ${nodes['DUT1']} | ${nodes['TG']}
| | And Start containers for device test
| | And Configure interfaces in path up
| | When Set up memif interfaces on DUT node | ${dut_node} | ${sock_base}
| | ... | ${sock_base} | dcr_uuid=${dcr_uuid}
| | ... | memif_if1=memif_if1 | memif_if2=memif_if2 | rxq=${0} | txq=${0}
| | And Create bridge domain | ${dut_node} | ${bd_id1}
| | And Add interface to bridge domain | ${dut_node} | ${dut_to_tg_if1}
| | ... | ${bd_id1}
| | And Add interface to bridge domain | ${dut_node} | ${memif_if1}
| | ... | ${bd_id1}
| | And Create bridge domain | ${dut_node} | ${bd_id2}
| | And Add interface to bridge domain | ${dut_node} | ${dut_to_tg_if2}
| | ... | ${bd_id2}
| | And Add interface to bridge domain | ${dut_node} | ${memif_if2}
| | ... | ${bd_id2}
| | Then Send ICMPv6 bidirectionally and verify received packets
| | ... | ${tg_node} | ${tg_to_dut_if1} | ${tg_to_dut_if2}