From 7b53c036e6bf56623b8273018ff1c8cc62847857 Mon Sep 17 00:00:00 2001 From: Ricardo Salveti Date: Mon, 25 Jul 2016 13:22:22 -0300 Subject: Imported Upstream version 16.07-rc4 Change-Id: Ic57f6a3726f2dbd1682223648d91310f45705327 Signed-off-by: Ricardo Salveti --- doc/guides/sample_app_ug/tep_termination.rst | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) (limited to 'doc/guides/sample_app_ug/tep_termination.rst') diff --git a/doc/guides/sample_app_ug/tep_termination.rst b/doc/guides/sample_app_ug/tep_termination.rst index 2d86a03a..c3d1e97c 100644 --- a/doc/guides/sample_app_ug/tep_termination.rst +++ b/doc/guides/sample_app_ug/tep_termination.rst @@ -59,8 +59,8 @@ This allows network isolation, QOS, etc to be provided on a per client basis. In a typical setup, the network overlay tunnel is terminated at the Virtual/Tunnel End Point (VEP/TEP). The TEP is normally located at the physical host level ideally in the software switch. Due to processing constraints and the inevitable bottleneck that the switch -becomes the ability to offload overlay support features becomes an important requirement. -Intel® XL710 10/40 G Ethernet network card provides hardware filtering +becomes, the ability to offload overlay support features becomes an important requirement. +Intel® XL710 10/40 Gigabit Ethernet network card provides hardware filtering and offload capabilities to support overlay networks implementations such as MAC in UDP and MAC in GRE. Sample Code Overview @@ -131,14 +131,14 @@ Compiling the Sample Code .. code-block:: console - CONFIG_RTE_LIBRTE_VHOST=n + CONFIG_RTE_LIBRTE_VHOST=y vhost user is turned on by default in the configure file config/common_linuxapp. To enable vhost cuse, disable vhost user. .. code-block:: console - CONFIG_RTE_LIBRTE_VHOST_USER=y + CONFIG_RTE_LIBRTE_VHOST_USER=n After vhost is enabled and the implementation is selected, build the vhost library. -- cgit 1.2.3-korg