diff options
Diffstat (limited to 'docs')
| -rw-r--r-- | docs/report/introduction/methodology_packet_latency.rst | 42 |
1 files changed, 26 insertions, 16 deletions
diff --git a/docs/report/introduction/methodology_packet_latency.rst b/docs/report/introduction/methodology_packet_latency.rst index 411fe3d6fe..b8df660539 100644 --- a/docs/report/introduction/methodology_packet_latency.rst +++ b/docs/report/introduction/methodology_packet_latency.rst @@ -1,23 +1,33 @@ Packet Latency -------------- -TRex Traffic Generator (TG) is used for measuring latency of VPP DUTs. -Reported latency values are measured using following methodology: +TRex Traffic Generator (TG) is used for measuring latency across 2-Node +and 3-Node SUT server topologies. TRex integrates `A High Dynamic Range +Histogram (HDRH) <http://hdrhistogram.org/>`_ code providing per packet +latency distribution for latency streams sent in parallel to the main +load packet streams. Packet latency is measured using following +methodology: -- Latency tests are performed at 100% of discovered NDR and PDR rates - for each throughput test and packet size (except IMIX). +- Latency tests are performed at following packet load levels: + + - No-Load: latency streams only. + - Low-Load: at 10% PDR. + - Mid-Load: at 50% PDR. + - High-Load: at 90% PDR. + - NDR-Load: at 100% NDR. + - PDR-Load: at 100% PDR. + +- Latency is measured for all tested packet sizes except IMIX due to + TG restriction. - TG sends dedicated latency streams, one per direction, each at the rate of 9 kpps at the prescribed packet size; these are sent in addition to the main load streams. -- TG reports min/avg/max latency values per stream direction, hence two - sets of latency values are reported per test case; future release of - TRex is expected to report latency percentiles. -- Reported latency values are aggregate across two SUTs if the three - node topology is used for given performance test; for per SUT latency, - reported value should be divided by two. -- 1usec is the measurement accuracy advertised by TRex TG for the setup - used in FD.io labs used by CSIT project. -- TRex setup introduces an always-on error of about 2*2usec per latency - flow additonal Tx/Rx interface latency induced by TRex SW writing and - reading packet timestamps on CPU cores without HW acceleration on NICs - closer to the interface line. +- TG reports Min/Avg/Max and HDRH latency values distribution per stream + direction, hence two sets of latency values are reported per test + case. +- Reported latency values are aggregate across tested topology. +- +/- 1 usec is the measurement accuracy advertised by TRex TG for the + setup used. +- TG setup introduces an always-on Tx/Rx interface latency of about 2 + * 2 usec per direction induced by TRex SW writing and reading packet + timestamps on CPU cores.
\ No newline at end of file |