diff options
Diffstat (limited to 'tests/suites/performance/Short_IPv6_Intel-X520-DA2.robot')
| -rw-r--r-- | tests/suites/performance/Short_IPv6_Intel-X520-DA2.robot | 194 |
1 files changed, 0 insertions, 194 deletions
diff --git a/tests/suites/performance/Short_IPv6_Intel-X520-DA2.robot b/tests/suites/performance/Short_IPv6_Intel-X520-DA2.robot deleted file mode 100644 index cf163a9e44..0000000000 --- a/tests/suites/performance/Short_IPv6_Intel-X520-DA2.robot +++ /dev/null @@ -1,194 +0,0 @@ -# Copyright (c) 2016 Cisco and/or its affiliates. -# Licensed under the Apache License, Version 2.0 (the "License"); -# you may not use this file except in compliance with the License. -# You may obtain a copy of the License at: -# -# http://www.apache.org/licenses/LICENSE-2.0 -# -# Unless required by applicable law or agreed to in writing, software -# distributed under the License is distributed on an "AS IS" BASIS, -# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. -# See the License for the specific language governing permissions and -# limitations under the License. - -*** Settings *** -| Resource | resources/libraries/robot/performance.robot -| Force Tags | 3_NODE_SINGLE_LINK_TOPO | PERFTEST | HW_ENV | PERFTEST_SHORT -| ... | NIC_Intel-X520-DA2 -| Suite Setup | 3-node Performance Suite Setup with DUT's NIC model -| ... | L3 | Intel-X520-DA2 - -| Suite Teardown | 3-node Performance Suite Teardown -| Test Setup | Setup all DUTs before test -| Test Teardown | Run Keywords | Remove startup configuration of VPP from all DUTs -| ... | AND | Show vpp trace dump on all DUTs -| Documentation | *Reference NDR throughput IPv6 routing verify test cases* -| ... -| ... | *[Top] Network Topologies:* TG-DUT1-DUT2-TG 3-node circular topology -| ... | with single links between nodes. -| ... | *[Enc] Packet Encapsulations:* Eth-IPv6 for IPv6 routing. -| ... | *[Cfg] DUT configuration:* DUT1 and DUT2 are configured with IPv6 -| ... | routing and two static IPv6 /64 route entries. DUT1 and DUT2 tested with -| ... | 2p10GE NIC X520 Niantic by Intel. -| ... | *[Ver] TG verification:* In short performance tests, TG verifies -| ... | DUTs' throughput at ref-NDR (reference Non Drop Rate) with zero packet -| ... | loss tolerance. Ref-NDR value is periodically updated acording to -| ... | formula: ref-NDR = 0.9x NDR, where NDR is found in RFC2544 long -| ... | performance tests for the same DUT configuration. Test packets are -| ... | generated by TG on links to DUTs. TG traffic profile contains two L3 -| ... | flow-groups (flow-group per direction, 253 flows per flow-group) with -| ... | all packets containing Ethernet header, IPv6 header and generated -| ... | payload. MAC addresses are matching MAC addresses of the TG node -| ... | interfaces. -| ... | *[Ref] Applicable standard specifications:* RFC2544. - -*** Test Cases *** -| TC01: Verify 78B ref-NDR at 2x 2.9Mpps - DUT IPv6 - 1thread 1core 1rxq -| | [Documentation] -| | ... | [Cfg] DUT runs IPv6 routing config with 1 thread, 1 phy core, \ -| | ... | 1 receive queue per NIC port. [Ver] Verify ref-NDR for 78 Byte -| | ... | frames using single trial throughput test. -| | [Tags] | 1_THREAD_NOHTT_RXQUEUES_1 | SINGLE_THREAD | NDR -| | ${framesize}= | Set Variable | 78 -| | ${duration}= | Set Variable | 10 -| | ${rate}= | Set Variable | 2.9mpps -| | Given Add '1' worker threads and rxqueues '1' without HTT to all DUTs -| | And Add all PCI devices to all DUTs -| | And Add No Multi Seg to all DUTs -| | And Apply startup configuration on all VPP DUTs -| | And IPv6 forwarding initialized in a 3-node circular topology -| | Then Traffic should pass with no loss | ${duration} | ${rate} -| | ... | ${framesize} | 3-node-IPv6 - -| TC02: Verify 1518B ref-NDR at 2x 812.74kpps - DUT IPv6 - 1thread 1core 1rxq -| | [Documentation] -| | ... | [Cfg] DUT runs IPv6 routing config with 1 thread, 1 phy core, \ -| | ... | 1 receive queue per NIC port. [Ver] Verify ref-NDR for 1518 Byte -| | ... | frames using single trial throughput test. -| | [Tags] | 1_THREAD_NOHTT_RXQUEUES_1 | SINGLE_THREAD | NDR -| | ${framesize}= | Set Variable | 1518 -| | ${duration}= | Set Variable | 10 -| | ${rate}= | Set Variable | 812743pps -| | Given Add '1' worker threads and rxqueues '1' without HTT to all DUTs -| | And Add all PCI devices to all DUTs -| | And Add No Multi Seg to all DUTs -| | And Apply startup configuration on all VPP DUTs -| | And IPv6 forwarding initialized in a 3-node circular topology -| | Then Traffic should pass with no loss | ${duration} | ${rate} -| | ... | ${framesize} | 3-node-IPv6 - -| TC03: Verify 9000B ref-NDR at 2x 138.58kpps - DUT IPv6 - 1thread 1core 1rxq -| | [Documentation] -| | ... | [Cfg] DUT runs IPv6 routing config with 1 thread, 1 phy core, \ -| | ... | 1 receive queue per NIC port. [Ver] Verify ref-NDR for 9000 Byte -| | ... | frames using single trial throughput test. -| | [Tags] | 1_THREAD_NOHTT_RXQUEUES_1 | SINGLE_THREAD | NDR -| | ${framesize}= | Set Variable | 9000 -| | ${duration}= | Set Variable | 10 -| | ${rate}= | Set Variable | 138580pps -| | Given Add '1' worker threads and rxqueues '1' without HTT to all DUTs -| | And Add all PCI devices to all DUTs -| | And Apply startup configuration on all VPP DUTs -| | And IPv6 forwarding initialized in a 3-node circular topology -| | Then Traffic should pass with no loss | ${duration} | ${rate} -| | ... | ${framesize} | 3-node-IPv6 - -| TC04: Verify 78B ref-NDR at 2x 5.9Mpps - DUT IPv6 - 2thread 2core 1rxq -| | [Documentation] -| | ... | [Cfg] DUT runs IPv6 routing config with 2 threads, 2 phy cores, \ -| | ... | 1 receive queue per NIC port. [Ver] Verify ref-NDR for 78 Byte -| | ... | frames using single trial throughput test. -| | [Tags] | 2_THREAD_NOHTT_RXQUEUES_1 | MULTI_THREAD | NDR -| | ${framesize}= | Set Variable | 78 -| | ${duration}= | Set Variable | 10 -| | ${rate}= | Set Variable | 5.9mpps -| | Given Add '2' worker threads and rxqueues '1' without HTT to all DUTs -| | And Add all PCI devices to all DUTs -| | And Add No Multi Seg to all DUTs -| | And Apply startup configuration on all VPP DUTs -| | And IPv6 forwarding initialized in a 3-node circular topology -| | Then Traffic should pass with no loss | ${duration} | ${rate} -| | ... | ${framesize} | 3-node-IPv6 - -| TC05: Verify 1518B ref-NDR at 2x 812.74kpps - DUT IPv6 - 2thread 2core 1rxq -| | [Documentation] -| | ... | [Cfg] DUT runs IPv6 routing config with 2 threads, 2 phy cores, \ -| | ... | 1 receive queue per NIC port. [Ver] Verify ref-NDR for 1518 Byte -| | ... | frames using single trial throughput test. -| | [Tags] | 2_THREAD_NOHTT_RXQUEUES_1 | MULTI_THREAD | NDR -| | ${framesize}= | Set Variable | 1518 -| | ${duration}= | Set Variable | 10 -| | ${rate}= | Set Variable | 812743pps -| | Given Add '2' worker threads and rxqueues '1' without HTT to all DUTs -| | And Add all PCI devices to all DUTs -| | And Add No Multi Seg to all DUTs -| | And Apply startup configuration on all VPP DUTs -| | And IPv6 forwarding initialized in a 3-node circular topology -| | Then Traffic should pass with no loss | ${duration} | ${rate} -| | ... | ${framesize} | 3-node-IPv6 - -| TC06: Verify 9000B ref-NDR at 2x 138.58kpps - DUT IPv6 - 2thread 2core 1rxq -| | [Documentation] -| | ... | [Cfg] DUT runs IPv6 routing config with 2 threads, 2 phy cores, \ -| | ... | 1 receive queue per NIC port. [Ver] Verify ref-NDR for 9000 Byte -| | ... | frames using single trial throughput test. -| | [Tags] | 2_THREAD_NOHTT_RXQUEUES_1 | MULTI_THREAD | NDR -| | ${framesize}= | Set Variable | 9000 -| | ${duration}= | Set Variable | 10 -| | ${rate}= | Set Variable | 138580pps -| | Given Add '2' worker threads and rxqueues '1' without HTT to all DUTs -| | And Add all PCI devices to all DUTs -| | And Apply startup configuration on all VPP DUTs -| | And IPv6 forwarding initialized in a 3-node circular topology -| | Then Traffic should pass with no loss | ${duration} | ${rate} -| | ... | ${framesize} | 3-node-IPv6 - -| TC07: Verify 78B ref-NDR at 2x 7.3Mpps - DUT IPv6 - 4thread 4core 2rxq -| | [Documentation] -| | ... | [Cfg] DUT runs IPv6 routing config with 4 threads, 4 phy cores, \ -| | ... | 2 receive queues per NIC port. [Ver] Verify ref-NDR for 78 Byte -| | ... | frames using single trial throughput test. -| | [Tags] | 4_THREAD_NOHTT_RXQUEUES_2 | MULTI_THREAD | NDR -| | ${framesize}= | Set Variable | 78 -| | ${duration}= | Set Variable | 10 -| | ${rate}= | Set Variable | 7.3mpps -| | Given Add '4' worker threads and rxqueues '2' without HTT to all DUTs -| | And Add all PCI devices to all DUTs -| | And Add No Multi Seg to all DUTs -| | And Apply startup configuration on all VPP DUTs -| | And IPv6 forwarding initialized in a 3-node circular topology -| | Then Traffic should pass with no loss | ${duration} | ${rate} -| | ... | ${framesize} | 3-node-IPv6 - -| TC08: Verify 1518B ref-NDR at 2x 812.74kpps - DUT IPv6 - 4thread 4core 2rxq -| | [Documentation] -| | ... | [Cfg] DUT runs IPv6 routing config with 4 threads, 4 phy cores, \ -| | ... | 2 receive queues per NIC port. [Ver] Verify ref-NDR for 1518 Byte -| | ... | frames using single trial throughput test. -| | [Tags] | 4_THREAD_NOHTT_RXQUEUES_2 | MULTI_THREAD | NDR -| | ${framesize}= | Set Variable | 1518 -| | ${duration}= | Set Variable | 10 -| | ${rate}= | Set Variable | 812743pps -| | Given Add '4' worker threads and rxqueues '2' without HTT to all DUTs -| | And Add all PCI devices to all DUTs -| | And Add No Multi Seg to all DUTs -| | And Apply startup configuration on all VPP DUTs -| | And IPv6 forwarding initialized in a 3-node circular topology -| | Then Traffic should pass with no loss | ${duration} | ${rate} -| | ... | ${framesize} | 3-node-IPv6 - -| TC09: Verify 9000B ref-NDR at 2x 138.58kpps - DUT IPv6 - 4thread 4core 2rxq -| | [Documentation] -| | ... | [Cfg] DUT runs IPv6 routing config with 4 threads, 4 phy cores, \ -| | ... | 2 receive queues per NIC port. [Ver] Verify ref-NDR for 9000 Byte -| | ... | frames using single trial throughput test. -| | [Tags] | 4_THREAD_NOHTT_RXQUEUES_2 | MULTI_THREAD | NDR -| | ${framesize}= | Set Variable | 9000 -| | ${duration}= | Set Variable | 10 -| | ${rate}= | Set Variable | 138580pps -| | Given Add '4' worker threads and rxqueues '2' without HTT to all DUTs -| | And Add all PCI devices to all DUTs -| | And Apply startup configuration on all VPP DUTs -| | And IPv6 forwarding initialized in a 3-node circular topology -| | Then Traffic should pass with no loss | ${duration} | ${rate} -| | ... | ${framesize} | 3-node-IPv6 |