diff options
Diffstat (limited to 'tests/vpp/perf/container_memif/2n-10ge2p1x710-eth-l2bd-32memif-2chain-16dcr-vppip4-mrr.robot')
| -rw-r--r-- | tests/vpp/perf/container_memif/2n-10ge2p1x710-eth-l2bd-32memif-2chain-16dcr-vppip4-mrr.robot | 124 |
1 files changed, 0 insertions, 124 deletions
diff --git a/tests/vpp/perf/container_memif/2n-10ge2p1x710-eth-l2bd-32memif-2chain-16dcr-vppip4-mrr.robot b/tests/vpp/perf/container_memif/2n-10ge2p1x710-eth-l2bd-32memif-2chain-16dcr-vppip4-mrr.robot deleted file mode 100644 index 14929f6bc2..0000000000 --- a/tests/vpp/perf/container_memif/2n-10ge2p1x710-eth-l2bd-32memif-2chain-16dcr-vppip4-mrr.robot +++ /dev/null @@ -1,124 +0,0 @@ -# Copyright (c) 2019 Cisco and/or its affiliates. -# Licensed under the Apache License, Version 2.0 (the "License"); -# you may not use this file except in compliance with the License. -# You may obtain a copy of the License at: -# -# http://www.apache.org/licenses/LICENSE-2.0 -# -# Unless required by applicable law or agreed to in writing, software -# distributed under the License is distributed on an "AS IS" BASIS, -# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. -# See the License for the specific language governing permissions and -# limitations under the License. - -*** Settings *** -| Resource | resources/libraries/robot/performance/performance_setup.robot -| ... -| Force Tags | 2_NODE_SINGLE_LINK_TOPO | PERFTEST | HW_ENV | MRR -| ... | NIC_Intel-X710 | ETH | L2BDMACLRN | BASE | MEMIF | DOCKER | 2R8C -| ... | NF_DENSITY | CHAIN | NF_VPPIP4 -| ... -| Suite Setup | Run Keywords -| ... | Set up 2-node performance topology with DUT's NIC model | L3 -| ... | Intel-X710 -| ... | AND | Set up performance test suite with MEMIF -| ... -| Suite Teardown | Tear down 2-node performance topology -| ... -| Test Setup | Set up performance test -| ... -| Test Teardown | Run Keywords -| ... | Tear down performance mrr test -| ... | AND | Tear down performance test with container -| ... -| Test Template | Local Template -| ... -| Documentation | *Raw results L2BD test cases with memif 2 chains 16 docker -| ... | containers* -| ... -| ... | *[Top] Network Topologies:* TG-DUT1-TG 2-node circular topology with -| ... | single links between nodes. -| ... | *[Enc] Packet Encapsulations:* Eth-IPv4 for L2 bridge domain. -| ... | *[Cfg] DUT configuration:* DUT1 is configured with two L2 bridge domains -| ... | and MAC learning enabled. DUT1 tested with 2p10GE NIC X710 by Intel. -| ... | Container is connected to VPP via Memif interface. Container is running -| ... | same VPP version as running on DUT. Container is limited via cgroup to -| ... | use cores allocated from pool of isolated CPUs. There are no memory -| ... | contraints. -| ... | *[Ver] TG verification:* In MaxReceivedRate test TG sends traffic -| ... | at line rate and reports total received/sent packets over trial period. -| ... | Test packets are generated by TG on links to DUTs. TG traffic profile -| ... | contains two L3 flow-groups (flow-group per direction, 254 flows per -| ... | flow-group) with all packets containing Ethernet header, IPv4 header -| ... | with IP protocol=61 and static payload. MAC addresses are matching MAC -| ... | addresses of the TG node interfaces. - -*** Variables *** -# X710-DA2 bandwidth limit -| ${s_limit}= | ${10000000000} -# Traffic profile: -| ${traffic_profile}= | trex-sl-2n3n-ethip4-ip4src254-2c8n -# Container -| ${container_engine}= | Docker -| ${container_chain_topology}= | chain_ip4 - -*** Keywords *** -| Local Template -| | [Documentation] -| | ... | [Cfg] DUT runs L2BD switching config. -| | ... | Each DUT uses ${phy_cores} physical core(s) for worker threads. -| | ... | [Ver] Measure MaxReceivedRate for ${framesize}B frames using single\ -| | ... | trial throughput test. -| | ... -| | ... | *Arguments:* -| | ... | - framesize - Framesize in Bytes in integer or string (IMIX_v4_1). -| | ... | Type: integer, string -| | ... | - phy_cores - Number of physical cores. Type: integer -| | ... | - rxq - Number of RX queues, default value: ${None}. Type: integer -| | ... -| | [Arguments] | ${framesize} | ${phy_cores} | ${rxq}=${None} -| | ... -| | Given Add worker threads and rxqueues to all DUTs | ${phy_cores} | ${rxq} -| | And Add PCI devices to all DUTs -| | ${max_rate} | ${jumbo} = | Get Max Rate And Jumbo And Handle Multi Seg -| | ... | ${s_limit} | ${framesize} -| | And Apply startup configuration on all VPP DUTs -| | And Set up performance test with containers -| | ... | nf_chains=${2} | nf_nodes=${8} | auto_scale=${False} -| | And Initialize L2 Bridge Domain for multiple chains with memif pairs -| | ... | nf_chains=${2} | nf_nodes=${8} | auto_scale=${False} -| | Then Traffic should pass with maximum rate -| | ... | ${max_rate}pps | ${framesize} | ${traffic_profile} - -*** Test Cases *** -| tc01-64B-1c-eth-l2bd-32memif-2chain-16dcr-vppip4-mrr -| | [Tags] | 64B | 1C -| | framesize=${64} | phy_cores=${1} - -| tc02-64B-2c-eth-l2bd-32memif-2chain-16dcr-vppip4-mrr -| | [Tags] | 64B | 2C -| | framesize=${64} | phy_cores=${2} - -| tc04-1518B-1c-eth-l2bd-32memif-2chain-16dcr-vppip4-mrr -| | [Tags] | 1518B | 1C -| | framesize=${1518} | phy_cores=${1} - -| tc05-1518B-2c-eth-l2bd-32memif-2chain-16dcr-vppip4-mrr -| | [Tags] | 1518B | 2C -| | framesize=${1518} | phy_cores=${2} - -| tc07-9000B-1c-eth-l2bd-32memif-2chain-16dcr-vppip4-mrr -| | [Tags] | 9000B | 1C -| | framesize=${9000} | phy_cores=${1} - -| tc08-9000B-2c-eth-l2bd-32memif-2chain-16dcr-vppip4-mrr -| | [Tags] | 9000B | 2C -| | framesize=${9000} | phy_cores=${2} - -| tc10-IMIX-1c-eth-l2bd-32memif-2chain-16dcr-vppip4-mrr -| | [Tags] | IMIX | 1C -| | framesize=IMIX_v4_1 | phy_cores=${1} - -| tc11-IMIX-2c-eth-l2bd-32memif-2chain-16dcr-vppip4-mrr -| | [Tags] | IMIX | 2C -| | framesize=IMIX_v4_1 | phy_cores=${2} |