diff options
Diffstat (limited to 'tests/vpp/perf/srv6/10ge2p1x520-ethip6srhip6-ip6base-srv6proxy-dyn-mrr.robot')
| -rw-r--r-- | tests/vpp/perf/srv6/10ge2p1x520-ethip6srhip6-ip6base-srv6proxy-dyn-mrr.robot | 169 |
1 files changed, 0 insertions, 169 deletions
diff --git a/tests/vpp/perf/srv6/10ge2p1x520-ethip6srhip6-ip6base-srv6proxy-dyn-mrr.robot b/tests/vpp/perf/srv6/10ge2p1x520-ethip6srhip6-ip6base-srv6proxy-dyn-mrr.robot deleted file mode 100644 index 4d84c9b430..0000000000 --- a/tests/vpp/perf/srv6/10ge2p1x520-ethip6srhip6-ip6base-srv6proxy-dyn-mrr.robot +++ /dev/null @@ -1,169 +0,0 @@ -# Copyright (c) 2018 Cisco and/or its affiliates. -# Licensed under the Apache License, Version 2.0 (the "License"); -# you may not use this file except in compliance with the License. -# You may obtain a copy of the License at: -# -# http://www.apache.org/licenses/LICENSE-2.0 -# -# Unless required by applicable law or agreed to in writing, software -# distributed under the License is distributed on an "AS IS" BASIS, -# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. -# See the License for the specific language governing permissions and -# limitations under the License. - -*** Settings *** -| Resource | resources/libraries/robot/performance/performance_setup.robot -| ... -| Force Tags | 3_NODE_SINGLE_LINK_TOPO | PERFTEST | HW_ENV | MRR -| ... | NIC_Intel-X520-DA2 | SRv6 | IP6FWD | FEATURE | SRv6_PROXY -| ... | SRv6_PROXY_DYN | MEMIF | LXC -| ... -| Suite Setup | Run Keywords -| ... | Set up 3-node performance topology with DUT's NIC model | L3 -| ... | Intel-X520-DA2 -| ... | AND | Set up performance test suite with MEMIF -| ... | AND | Set up performance test suite with Dynamic SRv6 proxy -| ... -| Suite Teardown | Tear down 3-node performance topology -| ... -| Test Setup | Set up performance test -| ... -| Test Teardown | Run Keywords -| ... | Tear down mrr test with SRv6 with encapsulation -| ... | AND | Tear down performance test with container -| ... -| Test Template | Local template -| ... -| Documentation | *Raw results for Segment routing over IPv6 dataplane with\ -| ... | Dynamic SRv6 proxy test cases* -| ... -| ... | *[Top] Network Topologies:* TG-DUT1-DUT2-TG 3-node circular topology\ -| ... | with single links between nodes. -| ... | *[Enc] Packet Encapsulations:* Eth-IPv6-SRH-IPv6 on DUT1-DUT2 and\ -| ... | DUTn->TG, Eth-IPv6 on TG->DUTn and DUTn-LXC for IPv6 routing over SRv6. -| ... | *[Cfg] DUT configuration:* DUT1 and DUT2 are configured with IPv6\ -| ... | routing and static route, SR policy and steering policy for one\ -| ... | direction and one SR behaviour (function) - End.AD - for other\ -| ... | direction. DUT1 and DUT2 are tested with 2p10GE NIC X520 Niantic\ -| ... | by Intel. -| ... | *[Ver] TG verification:* In MaxReceivedRate tests TG sends traffic\ -| ... | at line rate and reports total received/sent packets over trial period.\ -| ... | Test packets are generated by TG on\ -| ... | links to DUTs. TG traffic profile contains two L3 flow-groups\ -| ... | (flow-group per direction, 253 flows per flow-group) with\ -| ... | all packets containing Ethernet header,IPv6 header with static payload.\ -| ... | MAC addresses are matching MAC addresses of the TG node interfaces. -| ... | *[Ref] Applicable standard specifications:* SRv6 Network Programming -\ -| ... | draft 3 and Segment Routing for Service Chaining - internet draft 01. - -*** Variables *** -# X520-DA2 bandwidth limit -| ${s_limit}= | ${10000000000} -# SIDs -| ${dut1_sid1}= | 2002:1:: -| ${dut1_sid2}= | 2003:2:: -| ${dut1_bsid}= | 2002:1::1 -| ${dut2_sid1}= | 2002:2:: -| ${dut2_sid2}= | 2003:1:: -| ${dut2_bsid}= | 2003:1::1 -| ${out_sid1_1}= | 2002:3:: -| ${out_sid1_2}= | 2002:4:: -| ${out_sid2_1}= | 2003:3:: -| ${out_sid2_2}= | 2003:4:: -| ${sid_prefix}= | ${64} -# IP settings -| ${tg_if1_ip6_subnet}= | 2001:1:: -| ${tg_if2_ip6_subnet}= | 2001:2:: -| ${dut1_if1_ip6}= | 2001:1::1 -| ${dut1_if2_ip6}= | 2001:3::1 -| ${dut1-memif-1-if1_ip6}= | 3001:1::1 -| ${dut1-memif-1-if2_ip6}= | 3001:1::2 -| ${dut1_nh}= | 4002:: -| ${dut2_if1_ip6}= | 2001:3::2 -| ${dut2_if2_ip6}= | 2001:2::1 -| ${dut2-memif-1-if1_ip6}= | 3002:1::1 -| ${dut2-memif-1-if2_ip6}= | 3002:1::2 -| ${dut2_nh}= | 4001:: -| ${prefix}= | ${64} -# outer IPv6 header + SRH with 3 SIDs: 40+(8+3*16)B -| ${srv6_overhead_3sids}= | ${96} -# Traffic profile: -| ${traffic_profile}= | trex-sl-3n-ethip6-ip6src253 -# Container -| ${container_engine}= | LXC -| ${container_chain_topology}= | chain - -*** Keywords *** -| Local template -| | [Documentation] -| | ... | [Cfg] DUT runs IPv6 over SRv6 routing config with ${phy_cores} phy -| | ... | core(s). -| | ... | [Ver] Measure MaxReceivedRate for ${framesize}B frames using single\ -| | ... | trial throughput test. -| | ... -| | ... | *Arguments:* -| | ... | - framesize - Framesize in Bytes in integer or string (IMIX_v4_1). -| | ... | Type: integer, string -| | ... | - phy_cores - Number of physical cores. Type: integer -| | ... | - rxq - Number of RX queues, default value: ${None}. Type: integer -| | ... -| | [Arguments] | ${framesize} | ${phy_cores} | ${rxq}=${None} -| | ... -| | Given Add worker threads and rxqueues to all DUTs | ${phy_cores} | ${rxq} -| | And Add PCI devices to all DUTs -| | ${max_rate} | ${jumbo} = | Get Max Rate And Jumbo And Handle Multi Seg -| | ... | ${s_limit} | ${framesize} | overhead=${srv6_overhead_3sids} -| | And Apply startup configuration on all VPP DUTs -| | And Set up performance test with containers | nf_chains=${1} | nf_nodes=${1} -| | When Initialize IPv6 forwarding over SRv6 with endpoint to SR-unaware Service Function via 'dynamic_proxy' behaviour in 3-node circular topology -| | Then Traffic should pass with maximum rate -| | ... | ${max_rate}pps | ${framesize} | ${traffic_profile} - -*** Test Cases *** -| tc01-78B-1c-ethip6srhip6-ip6base-srv6proxy-dyn-mrr -| | [Tags] | 78B | 1C -| | framesize=${78} | phy_cores=${1} - -| tc02-78B-2c-ethip6srhip6-ip6base-srv6proxy-dyn-mrr -| | [Tags] | 78B | 2C -| | framesize=${78} | phy_cores=${2} - -| tc03-78B-4c-ethip6srhip6-ip6base-srv6proxy-dyn-mrr -| | [Tags] | 78B | 4C -| | framesize=${78} | phy_cores=${4} - -| tc04-1518B-1c-ethip6srhip6-ip6base-srv6proxy-dyn-mrr -| | [Tags] | 1518B | 1C -| | framesize=${1518} | phy_cores=${1} - -| tc05-1518B-2c-ethip6srhip6-ip6base-srv6proxy-dyn-mrr -| | [Tags] | 1518B | 2C -| | framesize=${1518} | phy_cores=${2} - -| tc06-1518B-4c-ethip6srhip6-ip6base-srv6proxy-dyn-mrr -| | [Tags] | 1518B | 4C -| | framesize=${1518} | phy_cores=${4} - -| tc07-9000B-1c-ethip6srhip6-ip6base-srv6proxy-dyn-mrr -| | [Tags] | 9000B | 1C -| | framesize=${9000} | phy_cores=${1} - -| tc08-9000B-2c-ethip6srhip6-ip6base-srv6proxy-dyn-mrr -| | [Tags] | 9000B | 2C -| | framesize=${9000} | phy_cores=${2} - -| tc09-9000B-4c-ethip6srhip6-ip6base-srv6proxy-dyn-mrr -| | [Tags] | 9000B | 4C -| | framesize=${9000} | phy_cores=${4} - -| tc10-IMIX-1c-ethip6srhip6-ip6base-srv6proxy-dyn-mrr -| | [Tags] | IMIX | 1C -| | framesize=IMIX_v4_1 | phy_cores=${1} - -| tc11-IMIX-2c-ethip6srhip6-ip6base-srv6proxy-dyn-mrr -| | [Tags] | IMIX | 2C -| | framesize=IMIX_v4_1 | phy_cores=${2} - -| tc12-IMIX-4c-ethip6srhip6-ip6base-srv6proxy-dyn-mrr -| | [Tags] | IMIX | 4C -| | framesize=IMIX_v4_1 | phy_cores=${4} |