blob: bd767e704cafdb171a37c14c82da5a7b29e3a648 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
|
# Copyright (c) 2016 Cisco and/or its affiliates.
# Licensed under the Apache License, Version 2.0 (the "License");
# you may not use this file except in compliance with the License.
# You may obtain a copy of the License at:
#
# http://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing, software
# distributed under the License is distributed on an "AS IS" BASIS,
# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
# See the License for the specific language governing permissions and
# limitations under the License.
*** Settings ***
| Resource | resources/libraries/robot/default.robot
| Resource | resources/libraries/robot/ipv4.robot
| Resource | resources/libraries/robot/ipv6.robot
| Resource | resources/libraries/robot/interfaces.robot
| Resource | resources/libraries/robot/bridge_domain.robot
| Resource | resources/libraries/robot/testing_path.robot
| Resource | resources/libraries/robot/traffic.robot
| Library | resources.libraries.python.Trace
| Library | resources.libraries.python.Tap
| Library | resources.libraries.python.Namespaces
| Library | resources.libraries.python.IPUtil
| Force Tags | HW_ENV | VM_ENV | 3_NODE_DOUBLE_LINK_TOPO
| Test Setup | Run Keywords | Func Test Setup
| ... | AND | Clean Up Namespaces | ${nodes['DUT1']}
| Test Teardown | Run Keywords | Func Test Teardown
| ... | AND | Clean Up Namespaces | ${nodes['DUT1']}
| Documentation | *Tap Interface Traffic Tests*
| ... | *[Top] Network Topologies:* TG=DUT1 2-node topology with two links
| ... | between nodes.
| ... | *[Enc] Packet Encapsulations:* Eth-IPv4-ICMPv4 for L2 switching of
| ... | IPv4.
| ... | *[Cfg] DUT configuration:* DUT1 and DUT2 are configured with L2
| ... | bridge-domain (L2BD) MAC learning enabled; Split Horizon Groups (SHG)
| ... | are set depending on test case; Namespaces (NM)
| ... | are set on DUT1 with attached linux-TAP.
| ... | *[Ver] TG verification:* Test ICMPv4 Echo Request packets
| ... | are sent by TG on link to DUT1; On receipt TG verifies packets
| ... | for correctness and their IPv4 src-addr, dst-addr, and MAC addresses.
| ... | *[Ref] Applicable standard specifications:*
*** Variables ***
| ${tap1_VPP_ip}= | 16.0.10.1
| ${tap1_NM_ip}= | 16.0.10.2
| ${tap1_NM_mac}= | 02:00:00:00:00:02
| ${tap_int1}= | tap_int1
| ${namespace1}= | nmspace1
| ${dut_ip_address}= | 192.168.0.1
| ${tg_ip_address}= | 192.168.0.2
| ${tg_ip_address_GW}= | 192.168.0.0
| ${prefix}= | 24
*** Test Cases ***
| TC01: Tap Interface IP Ping Without Namespace
| | [Documentation]
| | ... | [Top] TG-DUT1-TG.
| | ... | [Enc] Eth-IPv4-ICMPv4.
| | ... | [Cfg] On DUT1 configure two interface addresses with IPv4 of which
| | ... | one is TAP interface ( dut_to_tg_if and TAP ).
| | ... | and one is linux-TAP.
| | ... | [Ver] Packet sent from TG gets to the destination and ICMP-reply is
| | ... | received on TG.
| | Given Path for 2-node testing is set | ${nodes['TG']} | ${nodes['DUT1']}
| | ... | ${nodes['TG']}
| | And Interfaces in 2-node path are up
| | ${int1}= | And Add Tap Interface | ${dut_node} | ${tap_int1} |
| | And Set Interface Address
| | ... | ${dut_node} | ${int1} | ${tap1_VPP_ip} | ${prefix}
| | And Set Interface Address
| | ... | ${dut_node} | ${dut_to_tg_if1} | ${dut_ip_address} | ${prefix}
| | And Set Interface State | ${dut_node} | ${int1} | up
| | And Set Linux Interface MAC | ${dut_node} | ${tap_int1} | ${tap1_NM_mac}
| | And Set Linux Interface IP | ${dut_node}
| | ... | ${tap_int1} | ${tap1_NM_ip} | ${prefix}
| | And Add Route | ${dut_node}
| | ... | ${tg_ip_address_GW} | ${prefix} | ${tap1_VPP_ip}
| | And Add Arp On Dut | ${dut_node} | ${dut_to_tg_if1}
| | ... | ${tg_ip_address} | ${tg_to_dut_if1_mac}
| | And Add Arp On Dut | ${dut_node} | ${int1}
| | ... | ${tap1_NM_ip} | ${tap1_NM_mac}
| | Then Node replies to ICMP echo request | ${tg_node} | ${tg_to_dut_if1}
| | ... | ${dut_to_tg_if1_mac} | ${tg_to_dut_if1_mac}
| | ... | ${tap1_NM_ip} | ${tg_ip_address}
| TC02: Tap Interface IP Ping With Namespace
| | [Documentation]
| | ... | [Top] TG-DUT1-TG.
| | ... | [Enc] Eth-IPv4-ICMPv4.
| | ... | [Cfg] On DUT1 configure two interface addresses with IPv4 of which
| | ... | one is TAP interface ( dut_to_tg_if and TAP ).
| | ... | and one is linux-TAP in namespace.
| | ... | [Ver] Packet sent from TG gets to the destination and ICMP-reply is
| | ... | received on TG.
| | Given Path for 2-node testing is set | ${nodes['TG']} | ${nodes['DUT1']}
| | ... | ${nodes['TG']}
| | And Interfaces in 2-node path are up
| | ${int1}= | And Add Tap Interface | ${dut_node} | ${tap_int1} |
| | And Set Interface Address
| | ... | ${dut_node} | ${int1} | ${tap1_VPP_ip} | ${prefix}
| | And Set Interface Address
| | ... | ${dut_node} | ${dut_to_tg_if1} | ${dut_ip_address} | ${prefix}
| | And Set Interface State | ${dut_node} | ${int1} | up
| | When Create Namespace | ${dut_node} | ${namespace1}
| | And Attach Interface To Namespace | ${dut_node}
| | ... | ${namespace1} | ${tap_int1}
| | And Set Linux Interface MAC | ${dut_node}
| | ... | ${tap_int1} | ${tap1_NM_mac} | ${namespace1}
| | And Set Linux Interface IP | ${dut_node}
| | ... | ${tap_int1} | ${tap1_NM_ip} | ${prefix} | ${namespace1}
| | And Add Arp On Dut | ${dut_node} | ${dut_to_tg_if1}
| | ... | ${tg_ip_address} | ${tg_to_dut_if1_mac}
| | And Add Arp On Dut | ${dut_node} | ${int1}
| | ... | ${tap1_NM_ip} | ${tap1_NM_mac}
| | And Add Route | ${dut_node}
| | ... | ${tg_ip_address_GW} | ${prefix} | ${tap1_VPP_ip} | ${namespace1}
| | Then Node replies to ICMP echo request | ${tg_node} | ${tg_to_dut_if1}
| | ... | ${dut_to_tg_if1_mac} | ${tg_to_dut_if1_mac}
| | ... | ${tap1_NM_ip} | ${tg_ip_address}
|
