1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
|
# Copyright (c) 2016 Cisco and/or its affiliates.
# Licensed under the Apache License, Version 2.0 (the "License");
# you may not use this file except in compliance with the License.
# You may obtain a copy of the License at:
#
# http://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing, software
# distributed under the License is distributed on an "AS IS" BASIS,
# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
# See the License for the specific language governing permissions and
# limitations under the License.
*** Settings ***
| Resource | resources/libraries/robot/default.robot
| Resource | resources/libraries/robot/testing_path.robot
| Resource | resources/libraries/robot/ipv4.robot
| Resource | resources/libraries/robot/ipv6.robot
| Resource | resources/libraries/robot/map.robot
| Library | resources.libraries.python.Trace
| Force Tags | HW_ENV | VM_ENV | 3_NODE_DOUBLE_LINK_TOPO
| Test Setup | Run Keywords | Setup all DUTs before test
| ... | AND | Setup all TGs before traffic script
| Test Teardown | Show Packet Trace on All DUTs | ${nodes}
| Documentation | *Lightweight 4 over 6 test cases*
| ...
| ... | LW4o6 is a subset of MAP-E, with per-subscriber rules. It uses the
| ... | same tunneling mechanism and configuration as MAP-E. It does not use
| ... | embedded address bits.
| ...
| ... | *[Top] Network Topologies:* TG=DUT1 2-node topology with two links
| ... | between nodes.
| ... | *[Enc] Packet Encapsulations:* Eth-IPv4-UDP on TG_if1-DUT,
| ... | Eth-IPv6-IPv4-UDP on TG_if2_DUT.
| ... | *[Cfg] DUT configuration:* DUT1 is configured as lwAFTR.
| ... | *[Ver] TG verification:* Test UDP ICMP Echo Request in IPv4 are
| ... | sent to lwAFTR and are verified by TG for correctness their
| ... | encapsulation in IPv6 src-addr, dst-addr and MAC addresses.
| ... | *[Ref] Applicable standard specifications:* RFC7596 RFC7597.
*** Variables ***
| ${dut_ip4}= | 10.0.0.1
| ${dut_ip6}= | 2001:0::1
| ${ipv4_prefix_len}= | 24
| ${ipv6_prefix_len}= | 64
| ${lw_ipv4_pfx}= | 20.0.0.1/32
| ${lw_ipv6_pfx}= | 2001:1::/64
| ${lw_ipv6_src}= | 2001:1::1
| ${lw_psid_length}= | ${8}
| ${lw_psid_offset}= | ${6}
| ${lw_rule_psid}= | ${52}
| ${lw_rule_ipv6_dst}= | 2001:1::2
| ${test_ipv4_inside}= | 20.0.0.1
| ${test_ipv4_outside}= | 10.0.0.100
# test_port depends on psid, length, offset
| ${test_port}= | ${1232}
| ${test_icmp_id}= | ${1232}
*** Test Cases ***
| TC01: Encapsulate IPv4 into IPv6. IPv6 dst depends on IPv4 and UDP destination
| | [Documentation]
| | ... | [Top] TG=DUT1.
| | ... | [Enc] Eth-IPv4-UDP on TG_if1-DUT, Eth-IPv6-IPv4-UDP on TG_if2_DUT.
| | ... | [Cfg] On DUT1 configure Map domain and Map rule.
| | ... | [Ver] Make TG send non-encapsulated UDP to DUT; verify TG received
| | ... | IPv4oIPv6 encapsulated packet is correct.
| | ... | [Ref] RFC7596 RFC7597
| | ...
| | Given Path for 2-node testing is set
| | ... | ${nodes['TG']} | ${nodes['DUT1']} | ${nodes['TG']}
| | And Interfaces in 2-node path are up
| | And IP addresses are set on interfaces
| | ... | ${dut_node} | ${dut_to_tg_if1} | ${dut_ip4} | ${ipv4_prefix_len}
| | ... | ${dut_node} | ${dut_to_tg_if2} | ${dut_ip6} | ${ipv6_prefix_len}
| | And Add IP Neighbor
| | ... | ${dut_node} | ${dut_to_tg_if2} | ${lw_rule_ipv6_dst}
| | ... | ${tg_to_dut_if2_mac}
| | ${domain_index}=
| | ... | When Map Add Domain
| | ... | ${dut_node} | ${lw_ipv4_pfx} | ${lw_ipv6_pfx}
| | ... | ${lw_ipv6_src} | 0 | ${lw_psid_offset}
| | ... | ${lw_psid_length}
| | And Map Add Rule
| | ... | ${dut_node} | ${domain_index} | ${lw_rule_psid}
| | ... | ${lw_rule_ipv6_dst}
| | Then Send IPv4 UDP and check headers for lightweight 4over6
| | ... | ${tg_node} | ${tg_to_dut_if1} | ${tg_to_dut_if2}
| | ... | ${dut_to_tg_if1_mac} | ${test_ipv4_inside} | ${test_ipv4_outside}
| | ... | ${test_port} | ${tg_to_dut_if2_mac} | ${dut_to_tg_if2_mac}
| | ... | ${lw_rule_ipv6_dst} | ${lw_ipv6_src}
TC02: Encapsulate IPv4 ICMP into IPv6. IPv6 dst depends on IPv4 addr and ICMP ID
| | [Documentation]
| | ... | [Top] TG=DUT1.
| | ... | [Enc] Eth-IPv4-ICMP(type 0 and 8) on TG_if1-DUT, Eth-IPv6-IPv4-ICMP
| | ... | on TG_if2_DUT.
| | ... | [Cfg] On DUT1 configure Map domain and Map rule.
| | ... | [Ver] Make TG send non-encapsulated ICMP to DUT; verify TG received
| | ... | IPv4oIPv6 encapsulated packet is correct. Checks IPv6
| | ... | destination based on ICMP Identifier field.
| | ... | [Ref] RFC7596 section 8.1
| | ...
| | Given Path for 2-node testing is set
| | ... | ${nodes['TG']} | ${nodes['DUT1']} | ${nodes['TG']}
| | And Interfaces in 2-node path are up
| | And IP addresses are set on interfaces
| | ... | ${dut_node} | ${dut_to_tg_if1} | ${dut_ip4} | ${ipv4_prefix_len}
| | ... | ${dut_node} | ${dut_to_tg_if2} | ${dut_ip6} | ${ipv6_prefix_len}
| | And Add IP Neighbor
| | ... | ${dut_node} | ${dut_to_tg_if2} | ${lw_rule_ipv6_dst}
| | ... | ${tg_to_dut_if2_mac}
| | ${domain_index}=
| | ... | When Map Add Domain
| | ... | ${dut_node} | ${lw_ipv4_pfx} | ${lw_ipv6_pfx}
| | ... | ${lw_ipv6_src} | 0 | ${lw_psid_offset}
| | ... | ${lw_psid_length}
| | And Map Add Rule
| | ... | ${dut_node} | ${domain_index} | ${lw_rule_psid}
| | ... | ${lw_rule_ipv6_dst}
| | Then Send IPv4 ICMP and check headers for lightweight 4over6
| | ... | ${tg_node} | ${tg_to_dut_if1} | ${tg_to_dut_if2}
| | ... | ${dut_to_tg_if1_mac} | ${test_ipv4_inside} | ${test_ipv4_outside}
| | ... | ${test_icmp_id} | ${tg_to_dut_if2_mac} | ${dut_to_tg_if2_mac}
| | ... | ${lw_rule_ipv6_dst} | ${lw_ipv6_src}
TC03: Decapsulate IPv4 UDP from IPv6.
| | [Documentation]
| | ... | [Top] TG=DUT1.
| | ... | [Enc] Eth-IPv6-IPv4-UDP on TG_if2_DUT, Eth-IPv4-UDP on TG_if1-DUT.
| | ... | [Cfg] On DUT1 configure Map domain and Map rule.
| | ... | [Ver] Make TG send encapsulated UDP to DUT; verify TG received
| | ... | IPv4 non-encapsulated packet is correct.
| | ... | [Ref] RFC7596 RFC7597
| | ...
| | Given Path for 2-node testing is set
| | ... | ${nodes['TG']} | ${nodes['DUT1']} | ${nodes['TG']}
| | And Interfaces in 2-node path are up
| | And IP addresses are set on interfaces
| | ... | ${dut_node} | ${dut_to_tg_if1} | ${dut_ip4} | ${ipv4_prefix_len}
| | ... | ${dut_node} | ${dut_to_tg_if2} | ${dut_ip6} | ${ipv6_prefix_len}
| | And Add Arp on DUT
| | ... | ${dut_node} | ${dut_to_tg_if1}
| | ... | ${test_ipv4_outside}
| | ... | ${tg_to_dut_if1_mac}
| | ${domain_index}=
| | ... | When Map Add Domain
| | ... | ${dut_node} | ${lw_ipv4_pfx} | ${lw_ipv6_pfx}
| | ... | ${lw_ipv6_src} | 0 | ${lw_psid_offset}
| | ... | ${lw_psid_length}
| | And Map Add Rule
| | ... | ${dut_node} | ${domain_index} | ${lw_rule_psid}
| | ... | ${lw_rule_ipv6_dst}
| | Then Send IPv4 UDP in IPv6 and check headers for lightweight 4over6
| | ... | ${tg_node} | ${tg_to_dut_if2} | ${tg_to_dut_if1}
| | ... | ${dut_to_tg_if2_mac} | ${tg_to_dut_if2_mac}
| | ... | ${lw_ipv6_src} | ${lw_rule_ipv6_dst}
| | ... | ${test_ipv4_outside} | ${test_ipv4_inside} | ${test_port}
| | ... | ${tg_to_dut_if1_mac} | ${dut_to_tg_if1_mac}
|
