# Copyright (c) 2020 Cisco and/or its affiliates.
# Licensed under the Apache License, Version 2.0 (the "License");
# you may not use this file except in compliance with the License.
# You may obtain a copy of the License at:
#
# http://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing, software
# distributed under the License is distributed on an "AS IS" BASIS,
# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
# See the License for the specific language governing permissions and
# limitations under the License.
*** Settings ***
| Resource | resources/libraries/robot/shared/default.robot
|
| Force Tags | 3_NODE_SINGLE_LINK_TOPO | PERFTEST | HW_ENV | NDRPDR
| ... | NIC_Intel-X710 | ETH | IP4FWD | FEATURE | ACL | ACL_STATELESS
| ... | OACL | ACL10 | 100K_FLOWS | DRV_VFIO_PCI
| ... | RXQ_SIZE_0 | TXQ_SIZE_0
| ... | ethip4udp-ip4base-oacl10sl-100kflows
|
| Suite Setup | Setup suite single link | performance
| Suite Teardown | Tear down suite | performance
| Test Setup | Setup test | performance
| Test Teardown | Tear down test | performance | acl
|
| Test Template | Local Template
|
| Documentation | *RFC2544: Packet throughput IPv4 test cases with ACL*
|
| ... | *[Top] Network Topologies:* TG-DUT1-DUT2-TG 3-node circular topology\
| ... | with single links between nodes.
| ... | *[Enc] Packet Encapsulations:* Eth-IPv4-UDP for IPv4 routing.
| ... | *[Cfg] DUT configuration:* DUT1 and DUT2 are configured with IPv4\
| ... | routing and one static IPv4 /24 route entries. Required ACL rules are\
| ... | applied to output paths of both DUT1 intefaces. DUT1 and DUT2 are tested\
| ... | with ${nic_name}.\
| ... | *[Ver] TG verification:* TG finds and reports throughput NDR (Non Drop\
| ... | Rate) with zero packet loss tolerance and throughput PDR (Partial Drop\
| ... | Rate) with non-zero packet loss tolerance (LT) expressed in percentage\
| ... | of packets transmitted. NDR and PDR are discovered for different\
| ... | Ethernet L2 frame sizes using MLRsearch library.\
| ... | Test packets are generated by TG on links to DUTs. TG traffic profile\
| ... | contains two L3 flow-groups (flow-group per direction, ${flows_per_dir}\
| ... | flows per flow-group) with all packets containing Ethernet header, IPv4\
| ... | header with IP protocol=61 and static payload. MAC addresses are\
| ... | matching MAC addresses of the TG node interfaces.
| ... | *[Ref] Applicable standard specifications:* RFC2544.
*** Variables ***
| @{plugins_to_enable}= | dpdk_plugin.so | acl_plugin.so
| ${crypto_type}= | ${None}
| ${nic_name}= | Intel-X710
| ${nic_driver}= | vfio-pci
| ${nic_rxq_size}= | 0
| ${nic_txq_size}= | 0
| ${osi_layer}= | L3
| ${overhead}= | ${0}
# ACL test setup
| ${acl_action}= | permit
| ${acl_apply_type}= | output
| ${no_hit_aces_number}= | 10
| ${flows_per_dir}= | 100k
| ${ip_nr}= | ${100}
# starting points for non-hitting ACLs
| ${src_ip_start}= | 30.30.30.1
| ${dst_ip_start}= | 40.40.40.1
| ${ip_step}= | ${1}
| ${sport_start}= | ${1000}
| ${dport_start}= | ${1000}
| ${port_step}= | ${1}
| ${trex_stream1_subnet}= | 10.10.10.0/24
| ${trex_stream2_subnet}= | 20.20.20.0/24
# Traffic profile:
| ${traffic_profile}= | trex-sl-3n-ethip4udp-100u1000p-conc
*** Keywords ***
| Local Template
| | [Documentation]
| | ... | [Cfg] DUT runs IPv4 routing config.
| | ... | Each DUT uses ${phy_cores} physical core(s) for worker threads.
| | ... | [Ver] Measure NDR and PDR values using MLRsearch algorithm.\
| |
| | ... | *Arguments:*
| | ... | - frame_size - Framesize in Bytes in integer or string (IMIX_v4_1).
| | ... | Type: integer, string
| | ... | - phy_cores - Number of physical cores. Type: integer
| | ... | - rxq - Number of RX queues, default value: ${None}. Type: integer
| |
| | [Arguments] | ${frame_size} | ${phy_cores} | ${rxq}=${None}
| |
| | Set Test Variable | \${frame_size}
| |
| | Given Set Max Rate And Jumbo
| | And Add worker threads to all DUTs | ${phy_cores} | ${rxq}
| | And Pre-initialize layer driver | ${nic_driver}
| | And Apply startup configuration on all VPP DUTs
| | When Initialize layer driver | ${nic_driver}
| | And Initialize layer interface
| | And Initialize IPv4 routing with IPv4 ACLs on DUT1 in circular topology
| | ... | ${ip_nr}
| | Then Find NDR and PDR intervals using optimized search
*** Test Cases ***
| tc01-64B-1c-ethip4udp-ip4base-oacl10sl-100kflows-ndrpdr
| | [Tags] | 64B | 1C
| | frame_size=${64} | phy_cores=${1}
| tc02-64B-2c-ethip4udp-ip4base-oacl10sl-100kflows-ndrpdr
| | [Tags] | 64B | 2C
| | frame_size=${64} | phy_cores=${2}
| tc03-64B-4c-ethip4udp-ip4base-oacl10sl-100kflows-ndrpdr
| | [Tags] | 64B | 4C
| | frame_size=${64} | phy_cores=${4}
| tc04-1518B-1c-ethip4udp-ip4base-oacl10sl-100kflows-ndrpdr
| | [Tags] | 1518B | 1C
| | frame_size=${1518} | phy_cores=${1}
| tc05-1518B-2c-ethip4udp-ip4base-oacl10sl-100kflows-ndrpdr
| | [Tags] | 1518B | 2C
| | frame_size=${1518} | phy_cores=${2}
| tc06-1518B-4c-ethip4udp-ip4base-oacl10sl-100kflows-ndrpdr
| | [Tags] | 1518B | 4C
| | frame_size=${1518} | phy_cores=${4}
| tc07-9000B-1c-ethip4udp-ip4base-oacl10sl-100kflows-ndrpdr
| | [Tags] | 9000B | 1C
| | frame_size=${9000} | phy_cores=${1}
| tc08-9000B-2c-ethip4udp-ip4base-oacl10sl-100kflows-ndrpdr
| | [Tags] | 9000B | 2C
| | frame_size=${9000} | phy_cores=${2}
| tc09-9000B-4c-ethip4udp-ip4base-oacl10sl-100kflows-ndrpdr
| | [Tags] | 9000B | 4C
| | frame_size=${9000} | phy_cores=${4}
| tc10-IMIX-1c-ethip4udp-ip4base-oacl10sl-100kflows-ndrpdr
| | [Tags] | IMIX | 1C
| | frame_size=IMIX_v4_1 | phy_cores=${1}
| tc11-IMIX-2c-ethip4udp-ip4base-oacl10sl-100kflows-ndrpdr
| | [Tags] | IMIX | 2C
| | frame_size=IMIX_v4_1 | phy_cores=${2}
| tc12-IMIX-4c-ethip4udp-ip4base-oacl10sl-100kflows-ndrpdr
| | [Tags] | IMIX | 4C
| | frame_size=IMIX_v4_1 | phy_cores=${4}