1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
201
202
203
204
205
206
207
208
209
210
|
# Copyright (c) 2018 Cisco and/or its affiliates.
# Licensed under the Apache License, Version 2.0 (the "License");
# you may not use this file except in compliance with the License.
# You may obtain a copy of the License at:
#
# http://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing, software
# distributed under the License is distributed on an "AS IS" BASIS,
# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
# See the License for the specific language governing permissions and
# limitations under the License.
*** Settings ***
| Resource | resources/libraries/robot/performance/performance_setup.robot
| Library | resources.libraries.python.QemuUtils
| ...
| Force Tags | 3_NODE_SINGLE_LINK_TOPO | PERFTEST | HW_ENV | MRR
| ... | NIC_Intel-X520-DA2 | ETH | IP4FWD | BASE | VHOST | 1VM | VHOST_256
| ...
| Suite Setup | Set up 3-node performance topology with DUT's NIC model
| ... | L3 | Intel-X520-DA2
| Suite Teardown | Tear down 3-node performance topology
| ...
| Test Setup | Set up performance test
| Test Teardown | Tear down performance mrr test with vhost and VM with dpdk-testpmd
| ... | dut1_node=${dut1} | dut1_vm_refs=${dut1_vm_refs}
| ... | dut2_node=${dut2} | dut2_vm_refs=${dut2_vm_refs}
| ...
| Documentation | *Raw results IPv4 test cases with vhost*
| ...
| ... | *[Top] Network Topologies:* TG-DUT1-DUT2-TG 3-node circular topology
| ... | with single links between nodes.
| ... | *[Enc] Packet Encapsulations:* Eth-IPv4 for IPv4 routing.
| ... | *[Cfg] DUT configuration:* DUT1 and DUT2 are configured with IPv4
| ... | routing and two static IPv4 /24 route entries. Qemu Guest is connected
| ... | to VPP via vhost-user interfaces. Guest is running DPDK testpmd
| ... | interconnecting vhost-user interfaces using 5 cores pinned to cpus 5-9
| ... | and 2048M memory. Testpmd is using socket-mem=1024M (512x2M hugepages),
| ... | 5 cores (1 main core and 4 cores dedicated for io), forwarding mode is
| ... | set to mac, rxd/txd=256, burst=64. DUT1, DUT2 are tested with 2p10GE
| ... | NIC X520 Niantic by Intel.
| ... | *[Ver] TG verification:* In MaxReceivedRate test TG sends traffic
| ... | at line rate and reports total received/sent packets over trial period.
| ... | Test packets are generated by TG on links to DUTs. TG traffic profile
| ... | contains two L3 flow-groups (flow-group per direction, 253 flows per
| ... | flow-group) with all packets containing Ethernet header, IPv4 header
| ... | with IP protocol=61 and static payload. MAC addresses are matching MAC
| ... | addresses of the TG node interfaces.
*** Variables ***
# Socket names
| ${sock1}= | /tmp/sock-1-1
| ${sock2}= | /tmp/sock-1-2
# FIB tables
| ${fib_table_1}= | 100
| ${fib_table_2}= | 101
# X520-DA2 bandwidth limit
| ${s_limit}= | ${10000000000}
# Traffic profile:
| ${traffic_profile} | trex-sl-3n-ethip4-ip4src253
*** Keywords ***
| Check RR for eth-ip4base-eth-2vhostvr256-1vm
| | [Documentation]
| | ... | [Cfg] DUT runs IPv4 routing config with ${wt} thread, ${wt} phy\
| | ... | core, ${rxq} receive queue per NIC port.
| | ... | [Ver] Measure MaxReceivedRate for ${framesize} frames using single\
| | ... | trial throughput test.
| | ...
| | [Arguments] | ${framesize} | ${wt} | ${rxq}
| | ...
| | # Test Variables required for test and test teardown
| | Set Test Variable | ${perf_qemu_qsz} | 256
| | Set Test Variable | ${framesize}
| | ${get_framesize}= | Get Frame Size | ${framesize}
| | ${max_rate}= | Calculate pps | ${s_limit} | ${get_framesize}
| | ${dut1_vm_refs}= | Create Dictionary
| | ${dut2_vm_refs}= | Create Dictionary
| | Set Test Variable | ${dut1_vm_refs}
| | Set Test Variable | ${dut2_vm_refs}
| | ...
| | Given Add '${wt}' worker threads and '${rxq}' rxqueues in 3-node single-link circular topology
| | And Add PCI devices to DUTs in 3-node single link topology
| | And Run Keyword If | ${get_framesize} < ${1522}
| | ... | Add no multi seg to all DUTs
| | And Apply startup configuration on all VPP DUTs
| | When Initialize IPv4 forwarding with vhost in 3-node circular topology
| | ... | ${sock1} | ${sock2}
| | ${vm1}= | And Configure guest VM with dpdk-testpmd-mac connected via vhost-user
| | ... | ${dut1} | ${sock1} | ${sock2} | DUT1_VM1 | ${dut1_vif1_mac}
| | ... | ${dut1_vif2_mac}
| | Set To Dictionary | ${dut1_vm_refs} | DUT1_VM1 | ${vm1}
| | ${vm2}= | And Configure guest VM with dpdk-testpmd-mac connected via vhost-user
| | ... | ${dut2} | ${sock1} | ${sock2} | DUT2_VM1 | ${dut2_vif1_mac}
| | ... | ${dut2_vif2_mac}
| | Set To Dictionary | ${dut2_vm_refs} | DUT2_VM1 | ${vm2}
| | Run Keyword Unless | ${qemu_built} | Set Suite Variable | ${qemu_built}
| | ... | ${True}
| | Then Traffic should pass with maximum rate | ${perf_trial_duration}
| | ... | ${max_rate}pps | ${framesize} | ${traffic_profile}
*** Test Cases ***
| tc01-64B-1t1c-ethip4-ip4base-eth-2vhostvr256-1vm-mrr
| | [Documentation]
| | ... | [Cfg] DUT runs IP4 routing config with 1 thread, 1 phy core,\
| | ... | 1 receive queue per NIC port.
| | ... | [Ver] Measure MaxReceivedRate for ${framesize} frames using single\
| | ... | trial throughput test.
| | ...
| | [Tags] | 64B | 1T1C | STHREAD
| | ...
| | [Template] | Check RR for eth-ip4base-eth-2vhostvr256-1vm
| | framesize=${64} | wt=1 | rxq=1
| tc02-1518B-1t1c-ethip4-ip4base-eth-2vhostvr256-1vm
| | [Documentation]
| | ... | [Cfg] DUT runs IP4 routing config with 1 thread, 1 phy core,\
| | ... | 1 receive queue per NIC port.
| | ... | [Ver] Measure MaxReceivedRate for ${framesize} frames using single\
| | ... | trial throughput test.
| | ...
| | [Tags] | 1518B | 1T1C | STHREAD
| | ...
| | [Template] | Check RR for eth-ip4base-eth-2vhostvr256-1vm
| | framesize=${1518} | wt=1 | rxq=1
| tc03-IMIX-1t1c-ethip4-ip4base-eth-2vhostvr256-1vm-mrr
| | [Documentation]
| | ... | [Cfg] DUT runs IP4 routing config with 1 thread, 1 phy core,\
| | ... | 1 receive queue per NIC port.
| | ... | [Ver] Measure MaxReceivedRate for ${framesize} frames using single\
| | ... | trial throughput test.
| | ...
| | [Tags] | IMIX | 1T1C | STHREAD
| | ...
| | [Template] | Check RR for eth-ip4base-eth-2vhostvr256-1vm
| | framesize=IMIX_v4_1 | wt=1 | rxq=1
| tc04-64B-2t2c-ethip4-ip4base-eth-2vhostvr256-1vm-mrr
| | [Documentation]
| | ... | [Cfg] DUT runs IP4 routing config with 2 threads, 2 phy cores,\
| | ... | 1 receive queue per NIC port.
| | ... | [Ver] Measure MaxReceivedRate for ${framesize} frames using single\
| | ... | trial throughput test.
| | ...
| | [Tags] | 64B | 2T2C | STHREAD
| | ...
| | [Template] | Check RR for eth-ip4base-eth-2vhostvr256-1vm
| | framesize=${64} | wt=2 | rxq=1
| tc05-1518B-2t2c-ethip4-ip4base-eth-2vhostvr256-1vm-mrr
| | [Documentation]
| | ... | [Cfg] DUT runs IP4 routing config with 2 threads, 2 phy cores,\
| | ... | 1 receive queue per NIC port.
| | ... | [Ver] Measure MaxReceivedRate for ${framesize} frames using single\
| | ... | trial throughput test.
| | ...
| | [Tags] | 1518B | 2T2C | STHREAD
| | ...
| | [Template] | Check RR for eth-ip4base-eth-2vhostvr256-1vm
| | framesize=${1518} | wt=2 | rxq=1
| tc06-IMIX-2t2c-ethip4-ip4base-eth-2vhostvr256-1vm-mrr
| | [Documentation]
| | ... | [Cfg] DUT runs IP4 routing config with 2 threads, 2 phy cores,\
| | ... | 1 receive queue per NIC port.
| | ... | [Ver] Measure MaxReceivedRate for ${framesize} frames using single\
| | ... | trial throughput test.
| | ...
| | [Tags] | IMIX | 2T2C | STHREAD
| | ...
| | [Template] | Check RR for eth-ip4base-eth-2vhostvr256-1vm
| | framesize=IMIX_v4_1 | wt=2 | rxq=1
| tc07-64B-4t4c-ethip4-ip4base-eth-2vhostvr256-1vm-mrr
| | [Documentation]
| | ... | [Cfg] DUT runs IP4 routing config with 4 threads, 4 phy cores,\
| | ... | 2 receive queues per NIC port.
| | ... | [Ver] Measure MaxReceivedRate for ${framesize} frames using single\
| | ... | trial throughput test.
| | ...
| | [Tags] | 64B | 4T4C | STHREAD
| | ...
| | [Template] | Check RR for eth-ip4base-eth-2vhostvr256-1vm
| | framesize=${64} | wt=4 | rxq=2
| tc08-1518B-4t4c-ethip4-ip4base-eth-2vhostvr256-1vm-mrr
| | [Documentation]
| | ... | [Cfg] DUT runs IP4 routing config with 4 threads, 4 phy cores,\
| | ... | 2 receive queues per NIC port.
| | ... | [Ver] Measure MaxReceivedRate for ${framesize} frames using single\
| | ... | trial throughput test.
| | ...
| | [Tags] | 1518B | 4T4C | STHREAD
| | ...
| | [Template] | Check RR for eth-ip4base-eth-2vhostvr256-1vm
| | framesize=${1518} | wt=4 | rxq=2
| tc09-IMIX-4t4c-ethip4-ip4base-eth-2vhostvr256-1vm-mrr
| | [Documentation]
| | ... | [Cfg] DUT runs IP4 routing config with 4 threads, 4 phy cores,\
| | ... | 2 receive queues per NIC port.
| | ... | [Ver] Measure MaxReceivedRate for ${framesize} frames using single\
| | ... | trial throughput test.
| | ...
| | [Tags] | IMIX | 4T4C | STHREAD
| | ...
| | [Template] | Check RR for eth-ip4base-eth-2vhostvr256-1vm
| | framesize=IMIX_v4_1 | wt=4 | rxq=2
|
