summaryrefslogtreecommitdiffstats
path: root/extras/router-plugin/README.md
diff options
context:
space:
mode:
Diffstat (limited to 'extras/router-plugin/README.md')
-rw-r--r--extras/router-plugin/README.md49
1 files changed, 0 insertions, 49 deletions
diff --git a/extras/router-plugin/README.md b/extras/router-plugin/README.md
deleted file mode 100644
index 40363ef18..000000000
--- a/extras/router-plugin/README.md
+++ /dev/null
@@ -1,49 +0,0 @@
-# Configure VPP and FRRouting for OSPF6
-This document describes how to configure the VPP with hicn_router plugin and FRR to enable the OSPF protocol. The VPP and FRR
-are configured in a docker file.
-
-## DPDK configuration on host machine:
-
-- Install and configure dpdk
- - make install T=x86_64-native-linux-gcc && cd x86_64-native-linux-gcc && sudo make install
- - modprobe uio
- - modprobe uio_pci_generic
- - dpdk-devbind --status
- - the PCIe number of the desired device can be observed ("xxx")
- - sudo dpdk-devbind -b uio_pci_generic "xxx"
-## VPP configuration:
-
-- Run and configure the VPP (hICN router plugin is required to be installed in VPP)
- - set int state TenGigabitEtherneta/0/0 up
- - set int ip address TenGigabitEtherneta/0/0 a001::1/24
- - create loopback interface
- - set interface state loop0 up
- - set interface ip address loop0 b001::1/128
- - enable tap-inject # This creates the taps by router plugin
- - show tap-inject # This shows the created taps
- - ip mroute add ff02::/64 via local Forward # ff02:: is multicast ip address
- - ip mroute add ff02::/64 via TenGigabitEtherneta/0/0 Accept
- - ip mroute add ff02::/64 via loop0 Accept
-
-- Setup the tap interface
- - ip addr add a001::1/24 dev vpp0
- - ip addr add b001::1/128 dev vpp1
- - ip link set dev vpp0 up
- - ip link set dev vpp1 up
-
-## FRR configuration:
-
-- Run and configure FRRouting (ospf)
- - /usr/lib/frr/frrinit.sh start &
- - vtysh
- - configure terminal
- - router ospf6
- - area 0.0.0.0 range a001::1/24
- - area 0.0.0.0 range b001::1/128
- - interface vpp0 area 0.0.0.0
- - interface vpp1 area 0.0.0.0
- - end
- - wr
- - add "no ipv6 nd suppress-ra" to the first configurtion part of the /etc/frr/frr.conf
-After the following configuration, the traffic over tap interface can be observered through "tcpdump- i vpp1".
-The neighborhood and route can be seen by the "show ipv6 ospf6 neighbor/route".