diff options
Diffstat (limited to 'test/test_ip4_irb.py')
| -rw-r--r-- | test/test_ip4_irb.py | 50 |
1 files changed, 25 insertions, 25 deletions
diff --git a/test/test_ip4_irb.py b/test/test_ip4_irb.py index 1d55cef5d90..ef3dc1caf2b 100644 --- a/test/test_ip4_irb.py +++ b/test/test_ip4_irb.py @@ -42,10 +42,10 @@ class TestIpIrb(VppTestCase): def setUpClass(cls): """ #. Create BD with MAC learning enabled and put interfaces to this BD. - #. Configure IPv4 addresses on loopback interface and routed interface. - #. Configure MAC address binding to IPv4 neighbors on loop0. + #. Configure IPv4 addresses on BVI interface and routed interface. + #. Configure MAC address binding to IPv4 neighbors on bvi0. #. Configure MAC address on pg2. - #. Loopback BVI interface has remote hosts, one half of hosts are + #. BVI interface has remote hosts, one half of hosts are behind pg0 second behind pg1. """ super(TestIpIrb, cls).setUpClass() @@ -54,40 +54,40 @@ class TestIpIrb(VppTestCase): cls.bd_id = 10 cls.remote_hosts_count = 250 - # create 3 pg interfaces, 1 loopback interface + # create 3 pg interfaces, 1 BVI interface cls.create_pg_interfaces(range(3)) - cls.create_loopback_interfaces(1) + cls.create_bvi_interfaces(1) cls.interfaces = list(cls.pg_interfaces) - cls.interfaces.extend(cls.lo_interfaces) + cls.interfaces.extend(cls.bvi_interfaces) for i in cls.interfaces: i.admin_up() # Create BD with MAC learning enabled and put interfaces to this BD cls.vapi.sw_interface_set_l2_bridge( - rx_sw_if_index=cls.loop0.sw_if_index, bd_id=cls.bd_id, + rx_sw_if_index=cls.bvi0.sw_if_index, bd_id=cls.bd_id, port_type=L2_PORT_TYPE.BVI) cls.vapi.sw_interface_set_l2_bridge(rx_sw_if_index=cls.pg0.sw_if_index, bd_id=cls.bd_id) cls.vapi.sw_interface_set_l2_bridge(rx_sw_if_index=cls.pg1.sw_if_index, bd_id=cls.bd_id) - # Configure IPv4 addresses on loopback interface and routed interface - cls.loop0.config_ip4() + # Configure IPv4 addresses on BVI interface and routed interface + cls.bvi0.config_ip4() cls.pg2.config_ip4() - # Configure MAC address binding to IPv4 neighbors on loop0 - cls.loop0.generate_remote_hosts(cls.remote_hosts_count) - cls.loop0.configure_ipv4_neighbors() + # Configure MAC address binding to IPv4 neighbors on bvi0 + cls.bvi0.generate_remote_hosts(cls.remote_hosts_count) + cls.bvi0.configure_ipv4_neighbors() # configure MAC address on pg2 cls.pg2.resolve_arp() - # Loopback BVI interface has remote hosts, one half of hosts are behind + # BVI interface has remote hosts, one half of hosts are behind # pg0 second behind pg1 half = cls.remote_hosts_count // 2 - cls.pg0.remote_hosts = cls.loop0.remote_hosts[:half] - cls.pg1.remote_hosts = cls.loop0.remote_hosts[half:] + cls.pg0.remote_hosts = cls.bvi0.remote_hosts[:half] + cls.pg1.remote_hosts = cls.bvi0.remote_hosts[half:] def tearDown(self): """Run standard test teardown and log ``show l2patch``, @@ -220,32 +220,32 @@ class TestIpIrb(VppTestCase): Test scenario: - ip traffic from pg2 interface must ends in both pg0 and pg1 - - arp entry present in loop0 interface for destination IP - - no l2 entree configured, pg0 and pg1 are same + - arp entry present in bvi0 interface for destination IP + - no l2 entry configured, pg0 and pg1 are same """ stream = self.create_stream( - self.pg2, self.loop0, self.pg_if_packet_sizes) + self.pg2, self.bvi0, self.pg_if_packet_sizes) self.pg2.add_stream(stream) self.pg_enable_capture(self.pg_interfaces) self.pg_start() - packet_count = self.get_packet_count_for_if_idx(self.loop0.sw_if_index) + packet_count = self.get_packet_count_for_if_idx(self.bvi0.sw_if_index) rcvd1 = self.pg0.get_capture(packet_count) rcvd2 = self.pg1.get_capture(packet_count) - self.verify_capture(self.loop0, self.pg2, rcvd1) - self.verify_capture(self.loop0, self.pg2, rcvd2) + self.verify_capture(self.bvi0, self.pg2, rcvd1) + self.verify_capture(self.bvi0, self.pg2, rcvd2) self.assertListEqual(rcvd1.res, rcvd2.res) def send_and_verify_l2_to_ip(self): stream1 = self.create_stream_l2_to_ip( - self.pg0, self.loop0, self.pg2, self.pg_if_packet_sizes) + self.pg0, self.bvi0, self.pg2, self.pg_if_packet_sizes) stream2 = self.create_stream_l2_to_ip( - self.pg1, self.loop0, self.pg2, self.pg_if_packet_sizes) + self.pg1, self.bvi0, self.pg2, self.pg_if_packet_sizes) self.vapi.cli("clear trace") self.pg0.add_stream(stream1) self.pg1.add_stream(stream2) @@ -254,7 +254,7 @@ class TestIpIrb(VppTestCase): self.pg_start() rcvd = self.pg2.get_capture(514) - self.verify_capture_l2_to_ip(self.pg2, self.loop0, rcvd) + self.verify_capture_l2_to_ip(self.pg2, self.bvi0, rcvd) def test_ip4_irb_2(self): """ IPv4 IRB test 2 @@ -265,7 +265,7 @@ class TestIpIrb(VppTestCase): self.send_and_verify_l2_to_ip() # change the BVI's mac and resed traffic - self.loop0.set_mac(MACAddress("00:00:00:11:11:33")) + self.bvi0.set_mac(MACAddress("00:00:00:11:11:33")) self.send_and_verify_l2_to_ip() # check it wasn't flooded |