| Age | Commit message (Collapse) | Author | Files | Lines |
|---|
|
Add a bihash-based ACL lookup mechanism and make it a new default.
This changes the time required to lookup a 5-tuple match
from O(total_N_entries) to O(total_N_mask_types), where
"mask type" is an overall mask on the 5-tuple required
to represent an ACE.
For testing/comparison there is a temporary debug CLI
"set acl-plugin use-hash-acl-matching {0|1}", which,
when set to 0, makes the plugin use the "old" linear lookup,
and when set to 1, makes it use the hash-based lookup.
Based on the discussions on vpp-dev mailing list,
prevent assigning the ACL index to an interface,
when the ACL with that index is not defined,
also prevent deleting an ACL if that ACL is applied.
Also, for the easier debugging of the state, there are
new debug CLI commands to see the ACL plugin state at
several layers:
"show acl-plugin acl [index N]" - show a high-level
ACL representation, used for the linear lookup and
as a base for building the hashtable-based lookup.
Also shows if a given ACL is applied somewhere.
"show acl-plugin interface [sw_if_index N]" - show
which interfaces have which ACL(s) applied.
"show acl-plugin tables" - a lower-level debug command
used to see the state of all of the related data structures
at once. There are specifiers possible, which make
for a more focused and maybe augmented output:
"show acl-plugin tables acl [index N]"
show the "bitmask-ready" representations of the ACLs,
we well as the mask types and their associated indices.
"show acl-plutin tables mask"
show the derived mask types and their indices only.
"show acl-plugin tables applied [sw_if_index N]"
show the table of all of the ACEs applied for a given
sw_if_index or all interfaces.
"show acl-plugin tables hash [verbose N]"
show the 48x8 bihash used for the ACL lookup.
Change-Id: I89fff051424cb44bcb189e3cee04c1b8f76efc28
Signed-off-by: Andrew Yourtchenko <ayourtch@gmail.com>
|
|
A bihash-per-interface is convenient, but turns out tricky difficult from
the maintenance standpoint with the large number of interfaces.
This patch makes the sessions reside in a single hash table for all the interfaces,
adding the lower 16 bit of sw_if_index as part of the key into the previously
unused space.
There is a tradeoff, that a session with an identical 5-tuple and the same
sw_if_index modulo 65536 will match on either of the interfaces.
The probability of that is deemed sufficiently small to not worry about it.
In case it still happens before the heat death of the universe,
there is a clib_warning and the colliding packet will be dropped,
at which point we will need to bump the hash key size by another u64,
but rather not pay the cost of doing that right now.
Change-Id: I2747839cfcceda73e597cbcafbe1e377fb8f1889
Signed-off-by: Andrew Yourtchenko <ayourtch@gmail.com>
|
|
Add the logic to be able to use stateful ACLs in a multithreaded setup.
Change-Id: I3b0cfa6ca4ea8f46f61648611c3e97b00c3376b6
Signed-off-by: Andrew Yourtchenko <ayourtch@gmail.com>
|
|
Fix a logic error related to timing out of the connections
following the active one. To avoid this class of issue in
the future, create corresponding testcases, as well as some
trivial sanity testcases for both IPv4 and IPv6.
Since these tests are timing-dependent and take up time,
mark them as extended tests.
Change-Id: I2c72bad5efda7db8aa9cb05801fe47928dc47927
Signed-off-by: Andrew Yourtchenko <ayourtch@gmail.com>
|
|
(VPP-682)
This fixes the previously-implicit "drop all non-first fragments" behavior
to be more in line with security rules: a non-first fragment is treated
for the purposes of matching the ACL as a packet with the port
match succeeding. This allows to change the behavior to permit
the fragmented packets for the default "permit specific rules"
ruleset, but also gives the flexibility to block the non-initial
fragments by inserting into the begining a bogus rule
which would deny the L4 traffic.
Also, add a knob which allows to potentially turn this behavior off
in case of a dire need (and revert to dropping all non-initial fragments),
via a debug CLI.
Change-Id: I546b372b65ff2157d9c68b1d32f9e644f1dd71b4
Signed-off-by: Andrew Yourtchenko <ayourtch@gmail.com>
(cherry picked from commit 9fc0c26c6b28fd6c8b8142ea52f52eafa7e8c7ac)
|
|
L3 path support, L2+L3 unified processing node, skip IPv6 EH support.
Change-Id: Iac37a466ba1c035e5c2997b03c0743bfec5c9a08
Signed-off-by: Andrew Yourtchenko <ayourtch@gmail.com>
|
Andrew Yourtchenko