| Age | Commit message (Collapse) | Author | Files | Lines |
|---|
|
1 - interface-DPO
Used in the Data-plane to change a packet's input interface
2 - MPLS multicast FIB entry
Same as a unicast entry but it links to a replicate not a load-balance DPO
3 - Multicast MPLS tunnel
Update MPLS tunnels to use a FIB path-list to describe the endpoint[s]. Use the path-list to generate the forwarding chain (DPOs) to link to .
4 - Resolve a path via a local label (of an mLDP LSP)
For IP multicast entries to use an LSP in the replication list, we need to decribe the 'resolve-via-label' where the label is that of a multicast LSP.
5 - MPLS disposition path sets RPF-ID
For a interface-less LSP (i.e. mLDP not RSVP-TE) at the tail of the LSP we still need to perform an RPF check. An MPLS disposition DPO performs the MPLS pop validation checks and sets the RPF-ID in the packet.
6 - RPF check with per-entry RPF-ID
An RPF-ID is used instead of a real interface SW if index in the case the IP traffic arrives from an LSP that does not have an associated interface.
Change-Id: Ib92e177be919147bafeb599729abf3d1abc2f4b3
Signed-off-by: Neale Ranns <nranns@cisco.com>
|
|
allow this config to function:
set int ip address loop0 169.254.1.1/32 (the default GW address for attached hosts)
set int unnumbered af_packet0 use loop0 ('enable' IP on the host interface)
ip route add 192.168.1.1/32 via af_packet0 (where to find the host)
repeat for each host and host interface.
Inter-host communication is throught the /32 routes.
To allow this:
1 - attached host routes have the ATTACHED flag set, so the ARP code accepts then as legitimate sources
2 - unnumbered interfaces inherit the source address from the IP interface
Change-Id: Ib66c5f0e848c528f79372813adc3a0c11b50717f
Signed-off-by: Neale Ranns <nranns@cisco.com>
|
|
Change-Id: I7b51f88292e057c6443b12224486f2d0c9f8ae23
Signed-off-by: Damjan Marion <damarion@cisco.com>
|
Neale Ranns
Damjan Marion