summaryrefslogtreecommitdiffstats
path: root/test/vpp_ip_route.py
AgeCommit message (Collapse)AuthorFilesLines
2018-03-09MPLS Unifom modeNeale Ranns1-6/+38
- support both pipe and uniform modes for all MPLS LSP - all API programming for output-labels requires that the mode (and associated data) is specificed - API changes in MPLS, BIER and IP are involved - new DPO [sub] types for MPLS labels to handle the two modes. Change-Id: I87b76401e996f10dfbdbe4552ff6b19af958783c Signed-off-by: Neale Ranns <nranns@cisco.com>
2018-01-09DVR: run L3 output featuresNeale Ranns1-3/+5
- rename l2_bridged to is_dvr. Including on the ip.api this was new in the 18.01 release so no compatability issues. - steal the free space in vnet_buffer_opaque_t for use with flags. - run the ipX-output feature arc from the DVR DPO Change-Id: I040e5976d1dbe076fcdda3a40a7804f56337ce3f Signed-off-by: Neale Ranns <nranns@cisco.com>
2018-01-09BIER: missing endian swap for imposition object in API returnNeale Ranns1-0/+1
Change-Id: Iddd754d00ace3d042336e5c2c40431566275051a Signed-off-by: Neale Ranns <neale.ranns@cisco.com>
2017-11-09BIERNeale Ranns1-6/+22
- see draft-ietf-bier-mpls-encapsulation-10 - midpoint, head and tail functions - supported payload protocols; IPv4 and IPv6 only. Change-Id: I59d7363bb6fdfdce8e4016a68a9c8f5a5e5791cb Signed-off-by: Neale Ranns <nranns@cisco.com>
2017-11-07UDP Encapsulation.Neale Ranns1-0/+8
A UDP-encap object that particiapates in the FIB graph and contributes DPO to teh output chain. It thereofre resembles a tunnel but without the interface. FIB paths (and henace routes) can then be created to egress through the UDP-encap. Said routes can have MPLS labels, hence this also allows MPLSoUPD. Encap is uni-directional. For decap, one still registers with the UDP port dispatcher. Change-Id: I23bd345523b20789a1de1b02022ea1148ca50797 Signed-off-by: Neale Ranns <nranns@cisco.com>
2017-10-14Source Lookup progammable via APINeale Ranns1-0/+3
Change-Id: I5d5d4f22b6369d504455a644f73076d772fbcfb4 Signed-off-by: Neale Ranns <nranns@cisco.com>
2017-10-05Distributed Virtual Router SupportNeale Ranns1-0/+2
A distributed virtual router works by attmpeting to switch a packet, but on failing to find a local consumer (i.e. the packet is destined to a locally attached host) then the packet is sent unmodified 'upstream' to where the rest of the 'distributed' router is present. When L3 switching a packet this means the L2 header must not be modifed. This patch adds a 'l2-bridge' object to the L3 FIB which re-injects packets from the L3 path back into the L2 path - use with extreme caution. Change-Id: I069724eb45956647d7980cbe40a80a788ee6ee82 Signed-off-by: Neale Ranns <nranns@cisco.com>
2017-09-11FIB table add/delete APINeale Ranns1-0/+73
part 2; - this adds the code to create an IP and MPLS table via the API. - but the enforcement that the table must be created before it is used is still missing, this is so that CSIT can pass. Change-Id: Id124d884ade6cb7da947225200e3bb193454c555 Signed-off-by: Neale Ranns <nranns@cisco.com>
2017-08-08L2 over MPLSNeale Ranns1-7/+17
[support for VPWS/VPLS] - switch to using dpo_proto_t rather than fib_protocol_t in fib_paths so that we can describe L2 paths - VLIB nodes to handle pop/push of MPLS labels to L2 Change-Id: Id050d06a11fd2c9c1c81ce5a0654e6c5ae6afa6e Signed-off-by: Neale Ranns <nranns@cisco.com>
2017-05-24Missing VLIB node for IPv6 disposition from mcast MPLS LSPNeale Ranns1-4/+5
Change-Id: Ibc0e1910a4926fdfbf74571efb5fd5810bfa09da Signed-off-by: Neale Ranns <nranns@cisco.com>
2017-04-24Improve Load-Balance MAPsNeale Ranns1-17/+36
- only build them for popular path-lists (where popular means more than 64 children) the reason to have a map is to improve convergence speed for recursive prefixes - if there are only a few this technique is not needed - only build them when there is at least one path that has recursive constraints, i.e. a path that can 'fail' in a PIC scenario. - Use the MAPS in the switch path. - PIC test cases for functionality (not convergence performance) Change-Id: I70705444c8469d22b07ae34be82cfb6a01358e10 Signed-off-by: Neale Ranns <nranns@cisco.com>
2017-04-07MPLS McastNeale Ranns1-3/+35
1 - interface-DPO Used in the Data-plane to change a packet's input interface 2 - MPLS multicast FIB entry Same as a unicast entry but it links to a replicate not a load-balance DPO 3 - Multicast MPLS tunnel Update MPLS tunnels to use a FIB path-list to describe the endpoint[s]. Use the path-list to generate the forwarding chain (DPOs) to link to . 4 - Resolve a path via a local label (of an mLDP LSP) For IP multicast entries to use an LSP in the replication list, we need to decribe the 'resolve-via-label' where the label is that of a multicast LSP. 5 - MPLS disposition path sets RPF-ID For a interface-less LSP (i.e. mLDP not RSVP-TE) at the tail of the LSP we still need to perform an RPF check. An MPLS disposition DPO performs the MPLS pop validation checks and sets the RPF-ID in the packet. 6 - RPF check with per-entry RPF-ID An RPF-ID is used instead of a real interface SW if index in the case the IP traffic arrives from an LSP that does not have an associated interface. Change-Id: Ib92e177be919147bafeb599729abf3d1abc2f4b3 Signed-off-by: Neale Ranns <nranns@cisco.com>
2017-03-17Fix IP feature ordering.Neale Ranns1-0/+17
Drop comes before lookup when enabled. is_first_or_last is not required when setting a feature, the anchor is added in find_config_with_features(). Don't make the PG interfaces automatically L3 enabled, this way we can have tests that check the L3 protocol disbaled behaviour. Change-Id: Icef22a920b27ff9cec6ab2da6b05f05c532cb60f Signed-off-by: Neale Ranns <nranns@cisco.com>
2017-03-10Fix MAP-E UT. Add functionality in MAP code to delete the pre-resolved ↵Neale Ranns1-1/+9
next-hops. UT checks for no-leftover-state now pass Change-Id: I9e980ee117c0b6aebc6c7a0fcc153a7c0eaf0c72 Signed-off-by: Neale Ranns <nranns@cisco.com>
2017-03-09IMplementation for option to not create a FIB table entry when adding a ↵Neale Ranns1-34/+44
neighbor entry Change-Id: I952039e101031ee6a06e63f4c73d8eb359423e1a Signed-off-by: Neale Ranns <nranns@cisco.com>
2017-03-09Tests to target holes in adjacency and DPO test coverageNeale Ranns1-9/+22
Change-Id: Ic6ac7e441a7b75baa02f03c1585d1ae00903a399 Signed-off-by: Neale Ranns <nranns@cisco.com>
2017-02-20Python test IP and MPLS objects conform to infra.Neale Ranns1-12/+104
Add IP[46] MFIB dump. Change-Id: I4a2821f65e67a5416b291e4912c84f64989883b8 Signed-off-by: Neale Ranns <nranns@cisco.com>
2017-01-27IP Multicast FIB (mfib)Neale Ranns1-1/+100
- IPv[46] mfib tables with support for (*,G/m), (*,G) and (S,G) exact and longest prefix match - Replication represented via a new replicate DPO. - RPF configuration and data-plane checking - data-plane signals sent to listening control planes. The functions of multicast forwarding entries differ from their unicast conterparts, so we introduce a new mfib_table_t and mfib_entry_t objects. However, we re-use the fib_path_list to resolve and build the entry's output list. the fib_path_list provides the service to construct a replicate DPO for multicast. 'make tests' is added to with two new suites; TEST=mfib, this is invocation of the CLI command 'test mfib' which deals with many path add/remove, flag set/unset scenarios, TEST=ip-mcast, data-plane forwarding tests. Updated applications to use the new MIFB functions; - IPv6 NS/RA. - DHCPv6 unit tests for these are undated accordingly. Change-Id: I49ec37b01f1b170335a5697541c8fd30e6d3a961 Signed-off-by: Neale Ranns <nranns@cisco.com>
2017-01-26DHCPv[46] proxy testsNeale Ranns1-18/+49
Change-Id: I6aaf9c602cd515ed9d4416d286f9191d048c1a87 Signed-off-by: Neale Ranns <nranns@cisco.com>
2017-01-11make test: improve documentation and PEP8 complianceKlement Sekera1-22/+30
Change-Id: Ib4f0353aab6112fcc3c3d8f0bcbed5bc4b567b9b Signed-off-by: Klement Sekera <ksekera@cisco.com>
2016-12-14Ping response in a VRF context uses correct FIB for responseNeale Ranns1-1/+2
Change-Id: I3b626a1fb9d74ebc609ded14c16c5e3d5a1655ab Signed-off-by: Neale Ranns <nranns@cisco.com>
2016-12-02MPLS infrastructure improvmentsNeale Ranns1-3/+72
- deprecate MPLSoEth and MPLSoGRE; replace with generic MPLS tunnel. - deprecates CLI 'mpls encap ..'; replace with addition of MPLS out label to a route/tunnel. - support for MPLS 'routes', e.g. MPLS x-connects. - deprecates CLI 'mpls decap ..'; replace with 'mpls route .. ' Change-Id: Ibda46544912f880d0200f22bf9ff9b52828fcc2f Signed-off-by: Neale Ranns <nranns@cisco.com>
2016-11-22GRE tests and fixesNeale Ranns1-0/+46
Change-Id: I234240e9bdd4b69ad64a17b1449ae1e81c0edaca Signed-off-by: Neale Ranns <nranns@cisco.com>