summaryrefslogtreecommitdiffstats
path: root/test/vpp_mpls_tunnel_interface.py
AgeCommit message (Collapse)AuthorFilesLines
2018-06-22Revert "make test: fix broken interfaces"Ole Troan1-2/+3
This reverts commit d5c60b96a3fd93916fc4af5c8d6d25625c28242e. Change-Id: I3632b9c3f76c615aee897f28f76d094e7031e689 Signed-off-by: Ole Troan <ot@cisco.com>
2018-06-22make test: fix broken interfacesKlement Sekera1-3/+2
Change-Id: I2e092774f81503e04b53cc6c6b5d357fe3fc52ab Signed-off-by: Klement Sekera <ksekera@cisco.com>
2018-05-30make test: VPP-1288 fix bogus sw_if_index valuesKlement Sekera1-8/+6
Change-Id: I9a61538f4c832f09269c6ddfcd55f909003b8694 Signed-off-by: Klement Sekera <ksekera@cisco.com>
2018-03-09MPLS Unifom modeNeale Ranns1-3/+5
- support both pipe and uniform modes for all MPLS LSP - all API programming for output-labels requires that the mode (and associated data) is specificed - API changes in MPLS, BIER and IP are involved - new DPO [sub] types for MPLS labels to handle the two modes. Change-Id: I87b76401e996f10dfbdbe4552ff6b19af958783c Signed-off-by: Neale Ranns <nranns@cisco.com>
2017-08-08L2 over MPLSNeale Ranns1-2/+4
[support for VPWS/VPLS] - switch to using dpo_proto_t rather than fib_protocol_t in fib_paths so that we can describe L2 paths - VLIB nodes to handle pop/push of MPLS labels to L2 Change-Id: Id050d06a11fd2c9c1c81ce5a0654e6c5ae6afa6e Signed-off-by: Neale Ranns <nranns@cisco.com>
2017-04-07MPLS McastNeale Ranns1-0/+46
1 - interface-DPO Used in the Data-plane to change a packet's input interface 2 - MPLS multicast FIB entry Same as a unicast entry but it links to a replicate not a load-balance DPO 3 - Multicast MPLS tunnel Update MPLS tunnels to use a FIB path-list to describe the endpoint[s]. Use the path-list to generate the forwarding chain (DPOs) to link to . 4 - Resolve a path via a local label (of an mLDP LSP) For IP multicast entries to use an LSP in the replication list, we need to decribe the 'resolve-via-label' where the label is that of a multicast LSP. 5 - MPLS disposition path sets RPF-ID For a interface-less LSP (i.e. mLDP not RSVP-TE) at the tail of the LSP we still need to perform an RPF check. An MPLS disposition DPO performs the MPLS pop validation checks and sets the RPF-ID in the packet. 6 - RPF check with per-entry RPF-ID An RPF-ID is used instead of a real interface SW if index in the case the IP traffic arrives from an LSP that does not have an associated interface. Change-Id: Ib92e177be919147bafeb599729abf3d1abc2f4b3 Signed-off-by: Neale Ranns <nranns@cisco.com>