1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
|
# PNAT: 1:1 match and rewrite programmable NAT
PNAT is a stateless statically configured, match and rewrite plugin.
It uses a set of match and rewrite rules that are applied on the IP
input and output feature paths. A PNAT rule is unidirectional.
The match is done using up to a 6-tuple; IP source and destination address,
IP protocol, transport layer source and destination ports, and FIB table / interface index.
While multiple match/rewrite rules can be applied to an interface (per direction), the match
pattern must be the same across all rules on that interface/direction.
If required in the future, matching could be done using the general classifier, allowing matching
on any protocol field, as well having an ordered set of match patterns.
If the packet does not match, it will by default be passed to the next graph node in the feature chain.
If desired a different miss behaviour could be implemented, e.g. similarly to dynamic NAT, the packet punted to a slow path.
## Rewrite instructions
``` c
typedef enum {
PNAT_INSTR_NONE = 1 << 0,
PNAT_INSTR_SOURCE_ADDRESS = 1 << 1,
PNAT_INSTR_SOURCE_PORT = 1 << 2,
PNAT_INSTR_DESTINATION_ADDRESS = 1 << 3,
PNAT_INSTR_DESTINATION_PORT = 1 << 4,
} pnat_instructions_t;
```
These are the supported rewrite instructions.
The IP checksum and the TCP/UDP checksum are incrementally updated as required.
There are only a few "sanity checks" on the rewrites. For example, the rewrite in the outbound direction
is applied on the ip-output feature chain. If one were to rewrite the IP destination address, the routing
decision and determination of the next-hop has already been done, and the packet would still be forwarded
to the original next-hop.
|
