blob: ee3f814f5c3551e83de94959d8990896ab75a21c (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
|
# VPP SPAN implementation
This is a memo intended to contain documentation of the VPP SPAN implementation.
Everything that is not directly obvious should come here.
## Switched Port Analyzer (SPAN)
Port mirroring is used on a network switch to send a copy of network packets seen on one switch port to a network monitoring connection on another switch port.
Can be used by network engineers or administrators to measure performnce, analyze and debug data or diagnose errors on a network.
### RX traffic node
There is one static node to mirror incomming packets.
* span-input: Creates a copy of incomming buffer due to incomming buffers can be reused internally.
Chaining: dpdk-input -> span-input ->
* original buffer is sent to ethernet-input for processing
* buffer copy is sent to interface-output
### Configuration
SPAN supports the following CLI configuration commands:
#### Enable/Disable SPAN (CLI)
set interface span <if-name> [disable | destination <if-name>]
<if-name>: mirrored interface name
destination <if-name>: monitoring interface name
disable: delete mirroring
#### Enable/Disabl SPAN (API)
SPAN supports the following API configuration command:
sw_interface_span_enable_disable src GigabitEthernet0/8/0 dst GigabitEthernet0/9/0
sw_interface_span_enable_disable src_sw_if_index 1 dst_sw_if_index 2
src/src_sw_if_index: mirrored interface name
dst/dst_sw_if_index: monitoring interface name
#### Remove SPAN entry (API)
SPAN supports the following API configuration command:
sw_interface_span_enable_disable src_sw_if_index 1 dst_sw_if_index 2 disable
src_sw_if_index: mirrored interface name
dst_sw_if_index: monitoring interface name
### Configuration example
Mirror all packets on interface GigabitEthernet0/10/0 to interface GigabitEthernet0/11/0.
Configure IPv4 addresses on mirrored interface:
set interface ip address GigabitEthernet0/10/0 192.168.1.13/24
set interface state GigabitEthernet0/10/0 up
Configure IPv4 addresses on monitoring interface:
set interface ip address GigabitEthernet0/11/0 192.168.2.13/24
set interface state GigabitEthernet0/11/0 up
Configure SPAN
set span src GigabitEthernet0/10/0 dst GigabitEthernet0/11/0
### Operational data
Active SPAN mirroring CLI show command:
show interfaces span
Active SPAN mirroring API dump command:
sw_interface_span_dump
|
